project

After 265 hours the 70 degree started burning some oil due to a leaking valve seal. My machinist actually also mentioned the valves and rings were a bit tired as well so I decided to do a refresh. Some pics of the progress...A Wossner piston will be used along with a JD jetting fuel...

Hi All Just purchased a 2005 fs 650, my first Berg, so i thought I'd sign up, its only done 2000 miles, and Akropovic exhaust, but a bit of a dirty unmaintained example and not been used for a few years, but i have it now, i'll look after her. Needs lots fixing, rear brake master cylinder...

Well got my first introduction into berg ownership, bought a project off Bludgeoner. Ideally wanted to fire it up and give it a quick road test but it's got too many issues so had a spare hour today before work and did this [emoji33] Sent from my iPhone using Tapatalk

I got the Behr Cush rear wheel on the 07 550. Barely. The tire is an Avon trail rider 160/60/17 but was at least 5mm wider than the Michelin Pilot Power on my 650. That left me after offset with just 1 or 2mm on the left and about 5mm on the right. I have room for a slight shift to the right if...

Hello all, Been reading over gavBeys's rebuild thread and saw it was full of useful information. I've decided to start my own. A bit of background on me I am an Marine Engineer in the Navy. I work on nuclear subs. I am specifically a mechanical engineer. Electrics are voodoo but I'm getting...

Nice cheap project bike here for someone. It's an 02 FC550 road registered with V5 in my name (no MOT). Needs a few bits and pieces to complete, and a bit of tinkering, but it's mostly complete and more importantly - runs! Needs the following - Headlight (same as loads of early KTM EXC/LC4's...

Hello all, if all goes to plan I am soon to take on a slightly unusual project for me. I have been asked by a good old friend of mine to restore his late fathers 1997 FE 400e, one of two Husabergs he bought new in the UK back in 97. At the moment I know very little about the bike or even...

Un active forum....

Hi! Sorry for the large letters but im trying to compete with the enoumus photos..:mad::furious: hard to scale them down when i'm doin this on my phone I decided to get the frame powdercoated. I chose a dark blue colour:cold: What do you guys think?:unsure: Should i post pictures of it when i...

Howds! I've been posting here and there to ask for info and advice on that moneypit of a berg I bought a few months ago. Figured I'd better set up a single thread to record the epic journey! So first of all, I bought a really cheap "easy to fix" non-runner FS650. Went to see the bike with my...

Going to start with this; And with a bit of luck, hard work (and a stash of $) end up with something like this.

Hi all, with Flattracker, Mike the Mailman and Bomber on here with their Flattrackers i thought it was about time i put some details here of my lengthy build. It started when i got this in 2008, Great fun but too mad for the road so i put the knobblies on and started greenlaning again...

So here we go, as promised some pictures of my 650 fs full rebuild well under way......

Hello, so i'm rebuilding a husaberg fe 550 e 2008 some piscture how i make tearing down complete bike sandblaster frame with new coating and new plastics custom design graphics my cylinder head for a litle more power and flow :devil: 3 angle valve seat 30 / 45 /...

KTM seems willing to allow axle bearings to be a premature failure point by most engineering standards. So, after replacing far too many over the years, after playing with seals and injecting grease and still not seeing adequate lifespan, I'm going to take on a project and post it. But...

Hi. Im new here and new to burgers. I have a tatty 2001 470. And want to get it on the road. How do i register it? Its battered everywhere. So guna start with strip an powder coat frame... And finding lots of broken bits. Any one kno what model mine could b?

I have bought my bike in 06/2011 in almost new condition from first owner (330km on odo). This is how it looked like: Mods already on the bike: -black plastics -husaberg handguards -axle crash protection -blue fuelcap thingy First thing I did was get frame protectors on it At first I was...

we're doing a disability project for a great bloke from bath at the moment! He was knocked off his bike into oncoming traffic and is disabled from the nipples down. fit a as flee, great attitude - the old up-n-at-em! he has adapted a track day bike and goes to all the road race circuits...

Hello all, i want to start off by saying that i feel little lucky becoming Husaberg comunity member at all. I decided to buy a Berg by looking at : - Price - Usage - Design - power - Capability - Part avalibility I find theese bikes verry nice along with KTM . About myselv, i am a 22 year...

Hi guys, I am trying to reserect a Berg into a SuperMoto commuter and funds are tight. Along with everything else going on I am going to have to rebuild the stock DelOrto which I have torn down and cleaned. I would love to go with an FCR conversion but that is going to have to wait. I have...