models

Husaberg

Help Support Husaberg:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. Taffy

    parts manual for TE models 2012

    anyone have one of these as an on screen PDF etc? cheers Taffy
  2. FE350CS

    ?501 headers on a 350 (early models)

    Has anyone had experience with putting 501 headers on a 350? (early model engine, mine 92) Did the power delivery broaden or shift? I purchased a later model 501 FC pipe to replace my FE long one and it included the headers, measuring ID/OD they are 15% larger. Would take a bit of heat +...
  3. B

    Crankshaft End Float 98-00 Models (with Roller Bearing)

    There is plenty of information throughout this site relating to checking & setting crankshaft end float on 01 to 08 engines but i cant find anything on the 98 to 00 engines where a roller bearing has been retrofitted in place of a ball bearing. It is suggested that axial play on the 01 to 08...
  4. K

    Mx vs enduro muffler (early models)

    I just noticed that my bike has the mx muffler (FC in husaberg notation) although it's an enduro model (FE). When looking at photos and old brochures the FE muffler extend all the way to the mud guard/rear light and seem to be about 150-200 mm longer than the FC muffler which stops right after...
  5. G

    70 Degree models X51 under-seat resistor

    I was going through my electricals tidying things around the batter box on my 2010 FE390 when I ran into a 2-conductor connector that is called "X51 Resistor", "A7" in the manual circuit descriptions. It has a white w/blue stripe wire & a black/blue wire leading to it. The other side of the...
  6. T

    Different models of 70 degree trails riding..

    So I was heading for trails riding with my 570 and then gods decided to have my tire lock separate, which in effect meant I had a whole day on my buddies 450 2009. Such a lovely bike in mid twisties while the 570 is just too much. Noticed its much easier to dose the throttle on than on my 570...
  7. F

    spare connectors 2009-2012 fe models

    spare connectors for 2009-2012 bikes
  8. OldMan

    Skid plate for 2007 models

    Hello everyone, Just stumbled upon this picture: Does anyone know what skid plate is that and where can I get it (or anything similar, actually)? Thanks
  9. H

    fix for countershaft spline wear husabergs & ktm exc models?

    as noted elsewhere, the countershaft or drive shaft splines can wear prematurely on the 70 degree bergs and ktm exc models. it seems the steel of the shaft isn't always that hard... i was thinking of trying the dirt tricks washer but essentially it just looked like a stronger version of the...
  10. J

    2014 models

    http://www.husaberg.com/news/single/hus ... odels.html
  11. S

    New headlight for berg 70 degree models

    Hey been looking for ages to replace my headlight as I do a fair bit of night riding and want to go HID The main problem with this is you'd have to go twin bulb to ensure you don't blind drivers with your low beam. I was considering doing it to a trailtech x2 Dot approved light and...
  12. Taffy

    PETITION KTM ABOUT THE DROPPING OF THE LDC MODELS

    if Husaberg are pulling the pin on the LDCs shouldn't we let them know that this is wrong? like NOW! I think that this will be the end of Husaberg because there is little point in just re-badgeing a bloody KTM now is there! how mant badge-engineered bikes have you seen survive over the...
  13. E

    Any news on the 2012 Husaberg models?

    Really curious if they're going to: == introduce the DI two-smokers ... or just BNG for the current TEs == graft on a kickstarter to the FE 390 (grin) Cheers! E-Ticket
  14. T

    Husaberg 2T models

    So gents, what's the story on the Husaberg 2T models? Are the 2011 just blue KTM exc/xc-w models? Do we have any close up photos to see if the 2011 WEC bikes are R&D models? Any signs of different casting on the cyllinders indicating direct port EFI? What's the plan for the 2012 models? Has...
  15. 6

    Which KTM oil filter is it for the new models???

    So which one do we use in the new generation bergs?/ HF155 or HF652. Did a search but nothing concrete came up?? I think it should be HF652
  16. H

    Any tall folk out there on the newer models? Mods?

    I am (was) 6'4 245 lb. 53 and I have decided to buy a new bike and set er up for trailing. I have a 2004 550 FE that I bought new and like the motor on, but, I didn't put the $$ into the suspension to make it right. Even so I was thinking of raising the bars and dropping the pegs to make it...
  17. L

    FS: Slipper / anti hopping clutch for new FE models

    Hey guys, I have a slipper clutch out of a 2009 400 EXC-R and I was told it will also fit the new 390 / 450 / 570 Husaberg models. I know for sure that it fits the 2008-2011 400 / 450 / 530 EXC-Rs so maybe somebody can confirm that his is the same clutch? KTM SXS part number 78032000100 It was...
  18. S

    New Models for sale

    There are a campaign Husaberg where you can find new models to a lower price, if you choose, to acquire the same under this campaign. The same is in force until 30 April 2010, offering the ISV. The purchased Supermotard models will be entitled to an extra special offer, a Kit Enduro, which will...
  19. M

    New Models and Fuel Quality

    I think I can justify the 390 if I bring it north next year. It's the perfect upgrade for my 2 stroker and will let me get way out there with it's fuel economy. However. The 2 stroke digests what ever crap you put in it and I normaly salvage the bottom of aircraft gasoline barrels. Town gas...
  20. M

    2010 models?

    Has anyone got more info when the new models will hit Australia? My dealer cant tell me anything. Got a 390 on order????
Back
Top