metal

Hello guys, so I bought my 06 Husa fs 650c about a Year ago, and ride it like 25h or something till now, I don't know the engine hours because it's the C model (came without Speedometer) the bike looks great and runs great whit no strange noises from the engine, and every time I change the oil...

Hi! I have a husaberg 450fe 2006. I decide to order stainless oil filter but surprise, I order the short one and I have the long one in the bike. Can it be used in my 450? if so, Is there any utility to the short oil filter (cold, better pre-heat) vs long (heat, oil flow)? I double check...

I just bought a 2004 fs450 a few weeks ago, has 130 hours on it, previous owner rebuilt it at 100 hours. I just did my first oil change since I bought it and there was a lot of fairly large metal chunks and shavings on the drain plug. Screen was clean, filter was clean as well. I’ve heard that...

HI Battery wouldn't charge so I did preliminary tests with multi meter which indicated stator was grounding to earth. I removed stator and found small metal debris pieces which had caused damaged to stator and to wire insulation. (photos attached) (Not sure whether to post in Electrical or...

Just put the first 1.5 hours and 100km on my rebuild. I rode around the block taking it easy after rebuild, dropped the oil, couple little bits of metal, some gasket material. Did about 100km yesterday, not beating on it too hard, kept the RPMs fairly low. Dropped the oil again, I have 1...

Hi all, My 04 fs650e is showing me the signs of a serious failure (or something much more simple) and I'm hoping someone can shed some light on it before I go in blind. The last oil drop (350ks) has shown a heaps of small, square, shiny metallic, non-magnetic flakes. They are too small to...

On oil change there was a lot of filings + blue plastic in the mesh filter, having removed the clutch side cover I found that a tooth from the cam gear was missing, found it lying in the bottom of the casing. Question is are all the fliings from this or do I have other problems? I can only post...

My bike is a 2011 FE570S with 87 hours and about 3200 miles, mostly off road at high throttle... This is what I had in my oil change this afternoon. Please note that there were metal parts everywhere: Oil plug magnet Oil screen near thew oil plug magnet Banjo bolt oil screen in the engine...

Howdy! This bike is a mix of different parts; frame from 98 and engine from 2000. I recently did a oil change and inspected the filter. Behind the filter I found some metal bits that concerns me a bit. I do not have any experience with these engines, but this cannot in any way be normal or...

Here's my question: Is this normal ??? For me there's a lot of metal chip on the magnet... See the 2 pictures below. My bike is a 2011 FE570S with 2500 miles and 65 hours on the clock. I did the oil change tonight after 25 hours since the last oil change. Before the oil change the bike was...

TL;DR: bike wouldn't shift into 6th, lots of metal on the drain plug, next oil change looked great and 6th gear is fine now (was fine the next day, even before the oil change)... any idea wtf happened? Long winded story below, including a few iceland riding pics! Hey guys, During a 4 day...

Hey, I was doing an oil change today and have found some not too good looking bits of bearing maybe. Does anyone have any idea what it is?? I have over 200hrs on her so I knew some love would be due, but up till now I virtually get nothing on the magnet. Cheers.

I had a fail shift riding in heavy sand the other day and found this on my drain plug. i was shifting from 4 to 5th i think and it did not catch the gear engine reved up and wam slamed back into 4 This is an 1/4 inch 8mm socket beside them. could they have come from the fail shift...

is a possible when let out oil of my berg have on the magnet fine metal in oil, what is it thank you

Mine has been looking like this since the rebuild. Is that considered normal? Regards

I have just finished rebuilding my engine and have found small traces of metal on the mag plug after a 1 hour ride. I know it's normal to find some traces of metal in the oil after rebuilding an engine as parts have to seat themselves and what not, this is my first husaberg that I have rebuilt...

Hey guys, I did various searches but found no relevant info so... I bought a 2003 fs 650 2 months ago, after finally getting it started I warmed it up then changed the oil there were some small metal particles (+/-0.3mm diameter) in the oil but I wasn't too worried as It was probably a while...

Hi to everyone just a little help is needed, i drained my oil friday and left it draining for a couple of days, when i checked out the plastic filter there was a few small metalic deposites on it, but on closer inspection there was a 3/4 strand of metal in a circular formed piece, any help...

I have a problem!!! I checked my 1hr old oil and found it to be full of filing's. It is a 2007 450 with about 2000k on it. There are no large bits just real fine non magnetic shiny stuff. Not happy, I hade to ride a Jap bike on the weekend.

Hi all, I have been working on and am in the process of coverting my FE400 to start using 12 4200mah sub c NiMh cells as used in radio controlled cars. They spin the motor nice an quick and it fires into life much better. My question to you is how many volts is it safe to put down the white...