measurement

Heya Bergers. The short version: I have no way to measure my liner in order to spec a replacement piston. The long version: Some bearing noise and steel shavings on my drain plug inspired me to finally tear down my 2008 FE550 after 210 hours. I found my main bearings were toast (as...

Hey, Guys, Winter has come and it's time for me to rebuild my engine. I'm trying to figure out what size piston I would need to order. Does Anybody know the actual diameter of a 650cc -I piston ( the smaller piston) eg. 99.95mm. My liner is a little warped and I'm trying to see if a -I...

Has anybody got an old or new Conrod kit for a 450 FE 2005 to 2008 laying around, all i need is the measurement from the end of the pin to the center of the oil supply hole that aligns with the port in the crank journal. Thanks ORANGEBERG

Hi, I´m searching for the measure of a Fe550 2006 camshaft. Need the measure from the middle of one lob to the both offset for the roller bearings. (inner measure between roller bearings an middle of lob) Have a second camshaft which is 1,5 mm longer than the original issue unfortunatly I...

Was wondering if anybody has a copy of the fork measurement sheet for the 2007 Fe 450.Can' t seem to source a copy through local Husaberg dealers etc.

By the way does anyone know what the main bearing float/ play shoud be. We know it needs to be set right and not too tight, but what is the measurement??

Hi, I just washed my 02 FE400 Husaberg with warm/high pressure water (i know, i'm *****), and after that i don't have spark anymore. i have measured the stator impedances and they are ok, also i removed kill- and hi/lo switches out of the system, but i still do not get any spark. So...