impeller

I have a 2005 650 FSC. The water pump impeller has lost two blades. Do you know which impeller fits that? I’ve heard that a lot of KTM parts will fit the Hussa Berg. I’m having a hard time finding parts here in the US.

I am sure this has been covered, but could not find this specifically. I am needing to replace the starter clutch and cannot remove the H2O pump impeller after I removed the clip. Any help please. Thanks!

Shaft is scored and is leaking coolant. Can I replace the shaft easily ? Just the right side cover? Or do you have to split cases?

I'm sure that someone on this forum used a KTM impeller on the 650? More flow but needed slight mods to work. I've searched the threads high and low but can't find it! Anybody?

Hello husaberg forums, I accidentally dropped my water pump impeller pin into my water pump today and it fell all the way into my engine block. I tried using magnets and shaking the bike, it didnt fall out.. Any suggestions? Bike is a Husaberg FS650e from 2006.

Is there a Napa or generic part number for the circlip that retains the impeller? Or perhaps just the dimensions? 54 0471 100010 SICHERUNGSRING DIN0471-10X1 CIRCLIP DIN0471-10X1 I tried having my local napa match it, and while they have boxes and boxes of circlips, they couldn't make any...

Hi everyone. I am new here as I have recently purchased my first Husaberg, and am loving every minute of it.... Well, I took a bit of a spill in all my exuberation. I hit water the pump intake tube on a rock. Promptly my coolant started spraying out. After 5 seconds of stupidly :shock...

Anyone know what causes a drip from the water pump vent hole on a FS650? I saw a couple drips early in the day, and by the end of the races I could hear it boiling and steam was coming out the vent. I am only using water wetter due to track requirement. Ideas? Thanks!

Does anyone know who would make and sell an upgraded oil pump, and upgraded water pump impeller??? I checked www.jbsracing.co.uk, Their site says they make them. But I have tried to contact them by e-mail and phone several times and got no responce. Husa, 2000fc501 Thanks, Dean

My 06 450 fe started to make a rather loud noise in the engine and I shut her down right away and went home. Found the water pump impeller had 2 vanes missing as well as the clip to hold it. After removing the impeller I started the engine and it still had the loud engine rattle. Checked the...

Hi guys, I was after a dimension of the water pump impeller if anyone was able to help me out. The dimension I am after is the depth of the shaft boss (i.e. length of the surface which bears against the shaft). My impeller is able to float a couple of mm's on the shaft before being...

Must you still purchase the impellar shaft bearing in order to obtain the impeller shaft seal P.N. 0625 062013? Is there a cross reference P.N. for the seal only? Thanks, Eric

Anyone know of a water pump impeller for a 00 FE400E made of something other than plastic? Thanks in advance, husadawg 8)