heated

Finally installing grip heaters (KTM branded ones) on my 2011 FE570 Have done some research on where to get power but there doesn't seem to be a consensus Anyone willing to share their experience?

Anyone fitted the heated grips from enduro engineering ? I have a 2011 FE 450. Already fitted a electric fan so i cant use that spare plug.

hi guys im a new husaberg fe390 owner just picked my new toy on fri past having had jap bike for years i got a set of ktm heated grips and got them fitted on sat but i seem to not get any heat from them but checking the power i am getting 14v when the bike is running and the power seems to...

? does anyone know if the charging system will tolerate the draw? If so, who makes a good one that will fit my bike?

2010 FE 390 EU version. Help guys! I've just fitted symtec heated grip elements, everything went well until I tried to wire the main power. I found various likely feed wires, which were live only when motor running and all checked by multi-meter. Connected heated grip switch power wire, to these...

Well finally got around to finishing up a couple of home made temp controllers for the grip heater elements. It uses a 555 timer and power mosfet to control the heat using pulse width modulation. Temperature is controlled using a dial pot. It is based on a design I found on the net. Seems to...

For those of you that have installed heated grips, where did you get the power source from? FYI, this is for my '06, with the battery and starter removed. If it would work out, I think that the best location for pwoer would be from the connection for the electric fan.