grip

Anyone have any recommendations for better grip on the factory seat? Or potentially even something aftermarket as to not hurt the factory seat? This one's in good shape so I'd hate to tear it up just to not slide around. Bike is a 99 400fe. Thanks! Sent from my SM-G991U using Tapatalk

Finally installing grip heaters (KTM branded ones) on my 2011 FE570 Have done some research on where to get power but there doesn't seem to be a consensus Anyone willing to share their experience?

Hi, I want to install grip heaters on my FE570S but not sure where to get the power. I heard that it's possible to take the power from the fan connector (I don't use it). Is it true? Will there be power only when the engine is hot, thus sending power to the fan connector? Thanks!

I installed the Enduro Engineering Grip Heaters this weekend. It was a siple and sanitary instalation on my FE570S. First, the instalation of the grip heaters themselves is self explanatory, so I'm not going to write about that. The instalation of the wiring and mounting the switch is a little...

Hi guys. I´ve had 3 Husabergs by now. I wonder if anyone has found a solution for the stock seat cover which has poor grip and tends to get worse over time. In my last Husaberg I had to change the seat cover to a extra grip motocross black seat cover and it was great, it grabbed me and didn´t...

2010 FE 390 EU version. Help guys! I've just fitted symtec heated grip elements, everything went well until I tried to wire the main power. I found various likely feed wires, which were live only when motor running and all checked by multi-meter. Connected heated grip switch power wire, to these...

Enjoy [vimeo:xhiyou92]http://www.vimeo.com/9315348[/vimeo:xhiyou92] Looki

Hi there, I've installed grip heaters on my 09 FE450,but I'm not sure where to get the positive from I don't want to run a line back to the battery,I'd prefer to splice in,but where? I've only found one live wirefrom the ignition switch block,which is on,motor off or on. Should I use this or...

Hi. Just some photos what we use this winter on the ice. We have a 3km track and its fast. 700cc and a massive grip, due to the enginepower we just make long powerslides and we have controlled slides coming into the turns. Will take some photos next weekend. //Thomas

Well finally got around to finishing up a couple of home made temp controllers for the grip heater elements. It uses a 555 timer and power mosfet to control the heat using pulse width modulation. Temperature is controlled using a dial pot. It is based on a design I found on the net. Seems to...

Racing on a Husaberg 650 in SuperMoto, will a change from the heavier flywheel stock on FE model to the lighter flywheel from the mx model have any effect on the rear tire grip.Or what exactly does the flywheel weight affect?

I can never understand schematics, so if someone can tell me which wire to splice into for my heated grips I would appreciate it. thanx