fuse

bike died snow biking while in motion no nothing replaced fuse 5 and it worked again then died 5min later. The fuse kept blowing out every time while trying to start it. let it sit for two days inside replaced fuse 5 and bike turned over seems fine. Stripped bike down exposed wiring harness...

I picked up a FS570, I’ve got brake lights and turn signals but the headlights, rear running light, highbeam indicator don’t work. I’ve tested the lighting wiring harness and it was good, I pulled the light switch from my 390 and still no go. While the bike is running I’m not getting power to...

Hey I have an FE550 and the starter was working fine, albeit the sprague clutch was well worn out... I cranked it a heap in the shed the other night and the battery ran down a fair bit but it eventually started Now it's fully dead, the starter will not click or turn over at all. I have...

I would like to introduce myself as a new member to the group coming from Australia. I have recently purchased off my brother in law a 2009 FE 570 and am looking for some help re some issues I bought it with.(Knowingly only paid $1200) The bike will start and idle no problems, once I get on...

I have a 2011 FE570S. The headlight and taillight stopped working so I replaced the #3 fuse which was burned out. When I went to turn on the ignition switch the running light flashed and the whole bike lost power. When I turn the ignition switch I get absolutely no power. The bike does nothing...

Hi bergers, I was riding my 2010 FE390 today for about 1/2 hour when the engine suddenly cut out and wouldn't restart. Dragged it home, found that fuse F2 is blown, and blows whenever I crank the starter. Where should I look for the problem? It's not the fuel pump, I disconnected it and the...

Reassembling after doing the top end. Changed frames, repainted. I tested with a car battery the first time and the motor spun fine. It took a few minutes after I pressed the starter button before the starter began spinning the motor. I also thought it was odd that when I turned the key to...

Hi So i have pretty much pulled half my bike apart looking for a bare wire or something that would be causing a short. Basically what is happening is each time i hit the start button it will blow fuse #4. From what i have read in the manual fuse number 4 is for the speedo, blinker, horn, brake...

Hi all, Electrical problems with my 2012 FE390. I've recently done some electrical work and now every time I switch on the high beams the fuse blows, low beam works just fine. I've only made some very minor tweaks to pickup power for a Trail Tech Vapor and Montana GPS cradle, which I have...

Hi all, I would like to add a Powerlet Socket (or two) to my new HDB top clamp ensemble for heated clothing and general gadget goodness. Ideally I'd like to add a new fuse as there appear to be a couple of spare slots in the fusebox so the whole job is kind of OEMish (is that a word??) Not...

Hey guys. Ive got a fx 450 2010 model that i really get to enjoy. I had a fuel problem a few months ago and replaced the fuel pump and it ended up being a fuel pressure regulator! Yeah. I wonder how many peeps have ran into that problem! Anyway, i was riding with my nephews holding...

I have a problem that comes and goes. The headlight fuse will blow and I can replace and it may not happen again for several days. Any ideas on where to look first? The bike is a 2010 FE450. thanks HusaRod

just a quick question. what size fuse should be in the starter solenoid ? thanks

Ok, new problem. Headlight stopped working, fuse #3 was blown. Replaced fuse, fired the bike, turned on low beam, revved, turned the wheel a ok. Flipped to high beam, a ok for about 10 seconds then it blows the fuse again. Searched this site. Thanks again! Replaced the bulb with the one...

I had a lot of electrical troubles so I went through the whole wiring system finding 2 bare wires touching the frame and a couple smashed wires. I fixed all of these but now when I turn the bike on, it is fine with high beams on but when I switch to low beams, I blow either fuse 3 or 5 or both...

Hello all... I have a 2010 FE450 with a radiator fan installed (dealer). On the last two rides (very technical, gets really hot, fan always coming on), my fan just stops working after an hour or two of riding. The first time, after the ride I checked the fuse and it was blown, so I replaced it...

Two times a broken fuel pump fuse, what causes it ? Where that should be examined to find the cause of broken fuel pump fuse ? Thank you.

Funny one this fuse keeps blowing but not when you hit the starter it will start the bike grand but when go for a bit of a spin the next time i go to use it the fuse is blown stick new fuse in and it works alway but will be blown then after another spin you can ride for 5 mins and it might be...

An electrician I'm not. I have just installed lights on my '09 FE450. For the rear I plugged in the three pole molex plug under the battery box to the rear light and I used the two pole molex with a jumper from the white (power) wire to the green and yellow wire that my schematic indicates is...

Yesterday I was checking my front light to get it set up properly (it was shining in the air instead of on the ground) When I turned my headlight down i heard a cracky sound and then my light's just went out. I checked the lamp itself but that just works when i put 12v on it.. Now nothing...