fe390

2011 Berg FE390. Had it since 2014. Love the bike, light, nimble and fast. Many mods, but recently went back to stock sprockets - fabulous, recently replaced fork seals. Use it for single track and general enduro/exploring the bush. Best recent mod: new rims with Tubliss. After trying lots...

I recently bought a super low hour FE390 from a guy it had been sitting for about 2 years with old gas in it. I went though and removed all the old gas took the injector out and cleaned it up, ride like a dream for about 3 minutes when it just shut off. I could smell fuel so I took the seat off...

I’m in the middle of putting new fork springs on my buddies berg. The springs I ordered are 43mm x 505mm which from what I can tell matches the service manual for the FE models (open cartridge forks). The weird part is the springs that were in his forks measure 43mm x 485mm, which seems like...

Hi guys my front brake has stopped working, pads are fine etc. Tried bleeding but getting no pressure on lever just soft. Think a seal maybe gone. Anyway have been looking for a master cylinder repair kit for my 2012 model but can only find kit for rear brake. Does anyone know where I can get...

2011 FE390. Took the bike for a short ride today, about 30 miles on forestry roads. Nothing taxing on the bike. When I left the house it sounded a bit louder than normal and seemed to get worse throughout the ride. At first I thought it was just excessive extra noise from whatever the air filter...

Loving this bike!

I seen a comment on Facebook the other day about certain model exc ktm pre 2015 and the exhausts fitting the fe390. Is there any truth to this or has anyone done the swap?

iv had a quick look around and not finding much on this. My fe obviously has enduro suspension but now its duty is supermoto on road is there much that can be done to the suspension or are there spring and valve kits available to buy? Be great if anyone who has done the swap before could chime in

hey guys I'm converting my 11 fe390 to supermoto,just wondering what gearing people are using that have done this swap. It will be used for road use and not track

Looking to replace the headgasket on my FE390 2012, but 2 different references are proposed by my HVA dealer: 78030036000 78930036010 Which one is the right reference ? Both can be installed ? Cheers, Chris

I have a 2010 FE390 with the 70degree tank. The green/blue original fuel line ruptured last week so I replaced it with regular fuel line and reinstalled the check valve as I found it. It also had a shut off valve installed that was partially melted from the exhaust heat so I removed it. Prior to...

I have a 2010 FE390 with the 70degree tank. The green/blue original fuel line ruptured last week so I replaced it with regular fuel line and reinstalled the check valve as I found it. It also had a shut off valve installed that was partially melted from the exhaust heat so I removed it. Prior to...

Looking for a promotobillet stand for a 2010 fe390......I know...hard to find.....but I know someone has a spare lying around.....or has anyone tried to modify one from a different bike?...maybe a KTM...any info is appreciated

Hello everyone, have any of you ever seen anything like this? I bought a FE 390 2010 where the engine was supposedly rebuilt a few hours ago. Corresponding receipts are included. During the first oil change, I found the oil strainer like this... It looks like small pieces of...

2011 Husaberg FE390, bike is in good condition with 85 hours, 1483 miles. Clean title and it is street legal, blinkers, horn, etc. Rear tire is tubliss, front is regular. Bike has after market foot pegs, steg pedz with stock pegs, stock seat, extra tall seat, owners manual and some other extra...

Bike has approx 200+ hours and I'm going to check and possible replace piston this winter. Can someone give me the procedure on how to determine if I need the 94.94mm or 94.95mm or 94.96mm piston?

Hi all, Since today I am a proud owner of a Husaberg FE 390. The bike looks mint and can’t wait to take it out, absolute love it! Besides my Husaberg I ride a Montesa Cota 315r trails bike. IMO they make a nice match :D I will post some pictures when the rain has disappeared and look forward to...

Hello All! My ‘11 FE390 is stock including the factory Husaberg exhaust. I’ve been told by a couple of tuners that the stock exhaust is one of the first things I should swap out to let her breathe better. I can no longer find a new Akropovic and FMF doesn’t list my bike specifically. I’d like...

Help: 2011 FE390 dies once I put it in gear and try to let the clutch out. Has Rekluse Z-start Pro with new clutch pack. Have had no issues writing and starting since replacing clutch pack last year. Also has a recently replaced fuel pump. Bike was having difficulty starting. Replaced the...

Hey everyone, Been reading through several posts similar to this but haven’t had much luck as this is a slightly different situation. I have a 2010 FE390. I got an Acerbis VSL headlight (which is actually for newer model Husqvarnas) and while working to install it, somewhere along the way...