This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

dying

  1. W

    Uncontrollable revving and dying

    Hi all I recently bought a used 2013 250TE. Had it out for the first time today ran great for about 2 hours. Then it bogged down on me and died. It would not start for about 20 mins. When it did start it revved high all by itself, stayed high until I blipped throttle, it came back down and...
  2. T

    Dying after wading

    Hi, quiet often during a deep wading the bike will stall and refuses to start again. Drag it out of the gloop :mad: and have a cup of tea and she will start:) Anyone else had this problem ? I expect its electrical. TFDM
  3. J

    05 Fe550 dying

    bike started playing up today. kept spluttering and stalling whenever I pulled throttle hard, annoying cause its always right when I need the power! always started right back up again. am I right in assuming she is being starved of fuel? possible solutions? accelerator pump on its way out...
  4. L

    Brand New 390 dying!! Help

    2010 FE 390, 2 days old. Aggressive Map setting, dealer told me they removed something from the muffler to improve power, not sure what that was. Emissions or noise control likely. 2 rides so far. Yesterday, riding gently for break-in period, I noticed it start to hesitate and bog down after an...
  5. R

    1996 KTM 620 RXC dying problem

    Hello I am new here so be gentle... :oops: I know this is not a Husaberg bike, but you all seem so knowledgeable with bikes, I thought I'd give you all a try... hehehe O.k. here goes, I have a 1996 KTM 620 RXC LC4 bike with a dying problem, I fire the bike up cold and it fires...
  6. L

    Is my starter solenoid dying?

    Battery is juiced up, starter motor works fine. But when I push the button, the solenoid does not make one click but about 10 per second, uninterrupted, until I stop pushing the button. Is the solenoid dying? Or is there some kind of a drain somewhere? If yes, can I replace it with an...
  7. McMucker

    motor dying

    in your opinion what would you say would cause at motor to die at idle under hard braking. eg. doing a stoppie. My thoughts are too rich a main jet combined with a high needle causing a little fuel to surge forward under the momentum caused by the hard braking. Or possibly from pilot jet...