diameter

Hi all Just wondering if anyone can tell me the diameter of the lower bypass hose (from bottom of thermostat to bottom of RHS radiator) on a 2013 FE350? Mine has a bit of a bad kink and the hose is looking a little brittle so I want to replace it but would like to have a new one to put on...

Hi, Working on a little modification - and am trying to ascertain the inner diameter of the steering tube. My ID caliper arms can't clear the flared steering bearing races to effectively measure against the INNER walls of the head tube. Since the OD is 56mm, and I'm guessing a wall...

Hey all, My 07' is not exactly stock;). Is there anyway I can tell the front master cylinder diameter from the outside, without measuring the bore? Thanks!

does anyone here have a 390 crank laying in the workshop? I need the OD of the flywheels please? I'll also buy the crank assembly if anyone wants to sell? thanks Taffy

I have problem. Today I measured the diameter of hole in engine. This in which sits the liner. Just as making measurements of the cylinder or liner. I found that the hole is not perfectly a round. It's little oval. Diameter at the point where cases are connect is about 0,2-0,3mm smaller than on...

Looking for wheel axil diameter on a 2011 FE 570 s, thank you.

Hey, Guys, Winter has come and it's time for me to rebuild my engine. I'm trying to figure out what size piston I would need to order. Does Anybody know the actual diameter of a 650cc -I piston ( the smaller piston) eg. 99.95mm. My liner is a little warped and I'm trying to see if a -I...

does anyone know what the inside diameters for the coolant hoses on a fe 570 are?

Just a simple question, what is the stock bar diameter on an 09 fe570? I tried the search and couldn't find it. I'm camping without access to my bike and i need to know... Thanks guys

I believe 04 speedo's can have the wheel diameter changed by the abuser. (from 17-21 or vica versa) I cant find any reference to this in my manual. Can anyone enlighten me as to how to do this please? Then I can keep using my original speedo when I fit my motard wheels.

OK I'm buying parts for a bike not in my possession yet... I need hand guards so is the stock handle bar 7/8" (22.2mm) or 1-1/8" (28.6mm)? Thanks, Donald

need a dimension folks..... yokes / triple clamps up to '03 were considerably thinner than the later alloy post. but don't have the dimensions? can anyone tell me the diameter of the post where the two taper roller bearings fit please? regards Taffy

ihave an 01 650 i. i feel the std muffler is a bit restrictive,after pulling it apart and having a look at the internals .i,m thinking of ripping the guts out of my tailpipe/muffler and making it a straight through system,similar to the performance aftermarket jobs. this thing has a 35mm i.d...

I don't have easy access to the bike right now and want to order up some of those motion pro quick disconnects with the integral shutoff valves. Cheers Mark