brembo

I can't find the posts, but I've seen where people were asking about a replacement front brake slide pins (ktm doesn't offer it) i ordered Honda #45131-166-016 . It fit. The threads are a tiny bit shorter, but the rest is the same.

does anyone know where i can purchase just the sliding pin (not sure the right term) for the brembo front caliper? image attached so i can easily swap between 260 and 320 rotors?

hey everyone, was wondering if it is possible to replace my whole magura clutch system(master and slave cylinder) with a brembo system on my 2011 fs 570? Im tired of the magura leaking and not working properly and the brembo system on my KTM has had no problems so i would just like to switch to...

Hello, I want to ask if I could change the pump connector Husaberg FX 450 2011 Magura with pump KTM SX 250f 2010 Brembo? Will it work? I am not happy Magura changed entirely in upper pump handle checked whether the lower pump misses everything was fine and still drive like a time waste heat...

I'm replacing my read pads and disc, And my 2007 FE Berg has the Brembo Brakes. I'm removed the cotter/split pin, But the "bolt" holding it in doesn't seem to want to come out.... Any ideas?

Hey guys, new rider here (Canadian living in Iceland) with a 2008 fe450 having lots of trouble finding a replacement lever for the front brake... Long story that starts with me ordering from http://www.midwestme.com/pages/product.html thinking it would work. turns out this lever does not...

Does anyone know where I can buy caliper rebuild kits for my brembo brakes??? 02, fx470e ( prefer in the US) Thanks

Because I wear down a lot of pads & disks I'm always looking for the best deal. And although I'm very pleased withe the price and overall quality of, for instance, GoldFren brake pads I do prefer the original stuff so I tried to source down the original hardware. Through KTM the pads and disks...

Has anyone used any of these brackets to use a 4 pot caliper with a 320mm disc? http://www.yoyodyneti.com/ProductInfo.a ... id=70.2011 (016 and 017 are for KTM) http://www.ktmax.de/indexa.htm (select brake systems from catagory, then select caliper adaptor) I am asking specifically to...

Hi, i have a radial hand-break that comes all the way back, into the hand-grip. slowly, over the course of the last three months, it has lost it breaking ability. i bought this along with a KTM supermoto racer conversion kit last december from KTMcycle Hut . this didn't start happening until...

Anyone replace the stock FTE caliper with a radial Brembo? Is the caliper bolt spacing 100mm? Thanks, Mike

Hi, I am creating a supermotard from my husaberg FE400E '03, I already have supermoto rims (BEHR/KTM) and tyres. But now i bougt a Braking 320mm brake disc and a brembo 4 piston caliper and a FTE radial brake pump (from a 'real' husaberg supermotard) to replace the current front brake system...

I've just bought a brand ned Brembo master cylinder with the external fluid reservoir. What i am missing, is the hose between the master and reservoir. Will I need a special type of hose, or will anything do? Ahh Lovely