blown

I have bought an ‘09 570 with a blown crank and cyl as it was starved of oil. I’ll rebuild the motor and this bike will be my trail hack where my ‘11 570 will do more adventure rides as it is setup for this. I have a new crank to suit the 610 piston and the piston kit coming over from Norway...

Head Gasket blown on 2006 FE550 yesterday. Rode home fine, no water in oil just spitting out of the front of gasket by the head pipe. I am going to replace this next week, should I be replacing anything else while I am in there. I have 140 hours and 3000 miles on bike. Thanks

Hey guys a bit nervous, first post. A bit of background. I live in Australia on the mid north coast. Land of endless single line trails and hill climbs. I own 3 bikes, a 1981 tin tank WR 430 Husky, 1987 WR250 Husky and my pride and joy 2009 FE450. I purchased the berg with about 2000ks on the...

I've blown the #5 fuse 3 times this last week on my 2011 570S. Wiring loom demons?? It runs fine for a while, an hour or more with new fuse, then pop, another cooked one. Any other ideas?? Kim A.

Blown fe570 engine I am embarrassed to tell this story BUT it might help someone else from expensive engine damage. Four weeks back I disassembled my 2010 FE570 engine with about 7600 miles on it. I was seeing very small metal specks in the oil. The Husaberg engine parts were perfect, cylinder...

Can you help!!! my brother has bought a 2002/3 650fse with a blown head gasket when we removed the head the gasket had blown at the front we replaced the gasket torqued the head to 45nm and it ran for 20 mins or so and then blew at the rear.and when i say blew its distroyed!!!.Is that head...

I have 83 hours on a 09 fe 450 and need to rebuilt, new cylinder, piston rings and valve guides and new valves, I have not even adjusted valves yet as they were still in spec.. I just replaced clutch after burning middle three plates . I replaced as a set then cleaned filters , cleaned screen ...

Hey have a 08 FE550 with 8hours on it. has a baja designs dual sport kit on it that had been working just fine. over the peroid of 2hours the starter is sluggish and now doesn't turn the engine. always starts first kick. just now basically no power from the batteryand also the blinkers won't...

First time doing it. im not that mechanically minded but i need to replace. nearest dealer is 300kms away at the moment. Any helpful hints?

Hi, I am rebuilding my FE400 because of the chronic top end problems and other issues after 9 months I got it second hand. Actually I have not been able to drive it for long due to recurring mechanical problems. Recently I take the cylinder head off and the picture was depressing. You can...

Hi guys, I have an '04 FS650E that I ride pretty much every day to work and back. Had it for about 2 years with minimal problems, change the oil every 500kms and check valve clearances every few times, never been loose. So, about 12 months ago I bent a valve and had to get it replaced, not...

As the title says i keep blowing fuses. the bike starts o.k but every time i turn the engine off or stall, the bike will not restart. To get it to start again i have to replace the left hand fuse. I'm not to good with the electrical side of things Anyone have any suggestions?

:D Cruising at 4th at 100km/h when suddenly engine stop and locked rear wheel thoug something has happening in gearbox but nothing there unusual it is free to shift but can not kick start the motor.Check the oil it was new and filters also and oil is full of Fuel smell lika a gas station he he...

Hello All Joined up about a week ago, after i bought my new toy. The bike is a 2002 Fe650 IN SM spec. The bike has been a PITA to start when cold and hot. How ever today whilst out for a ride she died. I was riding along up a hill motor was under load 3/4 way throught revs in 6th...

Yesterday I was checking my front light to get it set up properly (it was shining in the air instead of on the ground) When I turned my headlight down i heard a cracky sound and then my light's just went out. I checked the lamp itself but that just works when i put 12v on it.. Now nothing...

So last month I posted a distressed message about my brand new bike W/1,400 miles of nice lazy miles on it and perfect maint blowing up .I thought that the engin Had blown up acording to the [so called] Berg dealer I bought it from.It turn's out that A nut came loos and took out a coupple of...

BLOWN UP FE650E YA about 10 minuets ago on my way home my brand new bike possible threw a ROD or piston. It almost killed me I was Passing a slower car It was going 30 in a 40 so I dropped a gear to catch up to my buddy on his FE450E and halfway past the car the motor locked and threw me...

Hi All, You may recall in one of my previous threads I wrote, I am trying to build up a stock of rewound stators mainly for the ease if somebody down under requires one I don't have to wait for theres to arrive I can send one straight out this will save a lot of down time for the customer. I...

HI, I have a 1996 FE350 that has been running great. Unfortunately, my head gasket started to leak when the last Husaberg dealer moved out of Denver. Has anyone used RTV sealant for this out there? i'm not sure if this would be a bad idea. Or better does anyone know where I can...

My 501 was rebuilt five hours ago by yours truly. Everything in order and things running smooth until I noticed dense blue smoke firing it up yesterday. Upon lifting the head I notice a lot of oil in the combustion chamber and when I took the left cover off I could see the main seal has popped...