I have a 2001 Husaberg FX 470e and it continues to overheat after idling in place for 10 minutes or more. The bike I believe is jetted properly I did the conversion to a keihin carb (FCRMX 41) with the suggested DMS needle and suggested jets. It runs great and starts very easily but when left...
2008 FE 650
Hello,
Been trying to chase down electrical issue for last month. Came home one night to no lights on bike. Ok! Was moron and had hit the starter button when bike was running... (never did this on Berg before)... so maybe my stupidity did it. Fuse was also blown.
Had to run...
Hello, i am hoping someone can help. i have 08 fe450 with around 2500 miles
500 of those my miles. all of a sudden i notice a lot of smoke, after close
inspection i find oil pooling up in air box, Lots of oil. HELP ME!
Hello, i am hoping someone can help. i have 08 fe450 with around 2500 miles
500 of those my miles. all of a sudden i notice a lot of smoke, after close
inspection i find oil pooling up in air box, Lots of oil. HELP ME!
Ill start with this:
I have wiring diagrams
Electrical is NOT my strong suit
My 01 fe650 has blown the headlight bulbs in my trail tech x2 halogen
This tells me too much voltage...ie not being regulated
I have the regulator, rectifier wired as per the diagram.
Grounds all seem good
When...
Reassembling after doing the top end. Changed frames, repainted.
I tested with a car battery the first time and the motor spun fine. It took a few minutes after I pressed the starter button before the starter began spinning the motor. I also thought it was odd that when I turned the key to...
Hi
So i have pretty much pulled half my bike apart looking for a bare wire or something that would be causing a short. Basically what is happening is each time i hit the start button it will blow fuse #4. From what i have read in the manual fuse number 4 is for the speedo, blinker, horn, brake...
Hus 650 2004
Just had the motor rebuilt, new mains, rings, new gaskets throughout.
Smoked on first fire up which I expected but won't clear. Big puff of white/grey smoke as I blip the throttle. Motor feels tight and powerful but seems very hot and stinks of oil. End of exhaust black oily soot...
Hi all,
Electrical problems with my 2012 FE390.
I've recently done some electrical work and now every time I switch on the high beams the fuse blows, low beam works just fine. I've only made some very minor tweaks to pickup power for a Trail Tech Vapor and Montana GPS cradle, which I have...
Why would my 550 blow the radiator hose off of the water pump housing? the first time was when I didnt get a full kick in on it I accidentally gave it a lil gas when kicking it, this resulted in me nearly getting thrown over the handle bars and the radiator hose? getting blown off the water pump...
Ok, new problem. Headlight stopped working, fuse #3 was blown. Replaced fuse, fired the bike, turned on low beam, revved, turned the wheel a ok. Flipped to high beam, a ok for about 10 seconds then it blows the fuse again.
Searched this site. Thanks again! Replaced the bulb with the one...
Hello all...
I have a 2010 FE450 with a radiator fan installed (dealer). On the last two rides (very technical, gets really hot, fan always coming on), my fan just stops working after an hour or two of riding. The first time, after the ride I checked the fuse and it was blown, so I replaced it...
Funny one this fuse keeps blowing but not when you hit the starter it will start the bike grand but when go for a bit of a spin the next time i go to use it the fuse is blown stick new fuse in and it works alway but will be blown then after another spin you can ride for 5 mins and it might be...
My 05 650 is blowing smoke (blue) but only when i start it. It has done about 800 kilometers and was run in very carefully.
The shop gave me the "only 2 rings high performance bike" excuse but i dont buy it. ( what sort of an add is it for Husaberg if every time i go riding with a group she...
I`am trying to get a idea on where to look on solving a problem.I run a 55w halogen light on my berg but lately the thing shoots them as fast as I put them in.What would cause that?Bad ground,switch or what?I have both lighting coils hooked up.I don`t think that would make a difference.Thanks...