bent

Hey All! I want to run through a brief history of an FE650 I need to move to someone else to find out what the UHE populace thinks I should do as a next step. I have an '04 FE650 that was purchased from the Corner Grass guys here in Alberta, Canada after they won the Endurance Ice Racing...

So after having my big 570 berg for a while and getting annoyed with how to change the rotary map switch settings i thought surely i could make something simple and effective. So after digging around my workshop and the electronics store i came up with the following. It was quite inexpensive...

Believe it or not.

G’day Guys. Further to the vibes I’m experiencing with this 610 I’m wondering whether the balancer has been left out by the previous owner. Nope. What I’m seeing is two balancers. One above left of the clutch and another in the opposite side in behind the stator cover. Can someone give me...

attached are pics of my lower engine mounts/frame. Can someone compare to their frame to see if my engine has tweaked. Bike is a 2011 390

Couple of issues guys Managed to somehow bend the bars on my '07 FE550, Who's running aftermarket bars, what do you recommend when it comes to handlebars? I have had a search and it's all confusing, what works better for what? I'm around 6ft 1, If height counts for anything Also, when...

Went down at slow speed the other week but a direct slam for the LH peg because the bike tucked under really quick on rock slab; iced over. Thought peg was bent at first but fear it's the frame. Clearance between the frame boss that the kickstart stop screws into and bottom chain guide was about...

During a sharp turn, in high grass, I drove with my front disk over a big rock. I didn't see it, nor felt it. Just heard it. Now the disk is bent to the extent that I lose brake pressure always at the same point of the disk. 1) Why does this happen and 2) Can I repair this and how? Thanks

On my '05 FE550 - the fuel line which goes from the Carb to the T connector (which in turn connects to the two lines going to the petcocks) has a leak in it. This is the line that has a very sharp bend to it that connects to the carb. I have a leak in this line and have tried replacing with a...

So, after a rather large crash in a race I've bent the rear subframe a bit, enough to have the exhaust not fit so well. I've bent the exhaust back to carry on racing. anyone managed to straighten a rear subframe yet? doesn't need to be 100%. I was going to just heat it up to soften it and see...

With less than 20 hrs on my last cam chain replacement. I broke another one this past weekend. I am thinking that it was my "at home" chain rivet job quality. Now I need to check the valves to see if they are bent. I am thinking of just rotating the cam and checking the valve clearance. I...

I need advice on a 2000 FC501. I bought it used not running. I took it to a local Husaberg dealer and they told me it has 4 bent valves and will cost around $1000 to fix it! Does anybody have any suggestions? I hate to spend that much money on it knowing I won't get it back out and if I do...

hi everyone my name is paul and i'm new on here, just registered, but been using this brilliant site for a week or two for some very useful information. iv'e just bought my second berg a 2002 fs650, i had a 2003 fs650 about 2 years ago and never had a problem with it then sold it and...

Does anypne have an old bent/broken frame they would sell ?

The other day while out in the depths of Hampshire, my friend broke down and I had to take him on the back of my 650 2002 Berg. It was a bit late when I realised these bikes were only designed for one person. The rear frame looks ok, has anyone else every bent a frame going 2 up ? Worried Lloyd.