axial

Just wondering here about end float? Just rebuilding a 628cc crank and about to check and adjust if need be the axial play. My other engines have always been around .75-.85mm without any adjustment and run perfectly. A quick measure of this engine ands its just over 1mm. What are the...

Axial clearance measured and it has 0.40mm clearance without gasket glue or whatever its named(permatex supra copper) between the blocks. Repair manual says 0.45mm-0.55mm. Good enough? or do I have to buy new bearing and add thinner shim?

Hi guys, Its been a while as ive been out on the bike ringing its neck everywhere :) oil change every 5 hours and nothing seems (touch wood) to be going wrong so pretty happy. Took off the cases to check axial play and for some reason im still getting nothing. I took the shim off...

Hi My engine has 0,7 axial clearance (roller bearings). Anyone know if this will be OK? Thanks Silverfx:eek:

Hi guys i rebuilt my bike about 15 hours ago and i decided to check crank axial play. i used to have ball bearing but now using ntn rollers. I cant seem to get any! not even the slightest bit of play?? the engine isnt tight and runs like a dream but i cant get play. im looking for circa...

Hi, I was checking axial play of crank on flywheel side, by pulling it out and in. Can it be measured like what I do on picture? I measure 0,6 mm, like what I was reading in 'doc, that is ok for 2 roller bearings. Do you know what type of bearings were used in FE501 2003, in spare part is...

Hello dear, I measure axial play of rockers on my FE501 2003, and it's way out specified in workshop manual. Manual says 0,1-0,15, while mine have exhaust 0,25 and inlet 0,4. I contact Husaberg dealer who said that this is normal and that he newer change any bushings. Also there is a small play...

Hey, im rebuilding my 04 fe 450 that had a knackered left main (roller). Im going for Enginehardwares method of using a roler on the right and a ball bearing on the left. I want to get the axial clearance right as this is obviously important so went and bought the tool for taking the roller...

Hi! I´m mounting the clutch now, and I noticed an axial play of 1mm, is that normal? Without the clutch mounted, the kickstarter works fine, but if I mount the clutch, I have no resistance 1/8 of one turn, and then solid stop. What have I done wrong? Can it be the resistance of all...

Could any one tell me what the axial clearance should be on the main gearbox shaft as I have finished doing a dry assembly but find that it has 0.05mm max (that’s with the right side bearing as far out as possible) , side to side clearance were as the driven shaft (sprocket) has perhaps...

I've lost the axial clearance on my crank! 8O Long story... Does anyone out there have the nominal measurements on: Distance between main bearings (roller) Crank width across the inner races It´s a 2003 650. Thanks! Dr_C