assembly

2008 FE 550 Can anyone verify where the hardware in the two pictures belongs? I've just recently finished assembling the engine after it being apart for quite some time and cannont exactly remember where these pieces of hardware belong. I did follow the instruction manual very closely...

looking for anyone who has one of these tailpieces on their bike/ probably a 1990-1996? do you have it with the taillight? cheers taffy

Can the kickstart assembly be removed, shaft, cogs 5 and 4, or does part 5 support the clutch hub? I'm thinking of removing the whole assembly to save weight and replace with a aluminium plug. Can't use the kickstart in this chassis and it's about 1kg! Every bit helps!;)

I am replacing the clutch master cylinder piston with the OEM repair kit. Have the kit, but I notice on the master cylinder has a small hole where it looks like a spring should sit. I don't remember one being there. I have photographed the hole (at the 6 oclock position on the master cylinder)...

Hello I just bought Fe 650 and previous owner messed with kickstarter so it was jammed. I removed assembly and there was little damage caused by wrong fitting. I tried to re-install assembly, it seemed fine before bolting clutch. Kickstarter gear moved freely both directions until lever was...

Hey guys, Today i took out the Rekluse z-start pro out of my 2010 390, to re-install the OEM clutch. I bought the bike second hand with the Rekluse installed, so i haven't had it all apart myself before. So i managed to get it all back together without a workshop manual, started it up, no bad...

hi all, where the clutch rod hits on both ends, one at the hyd. cylinder and the other in the clutch assembly, are there ballbearings or something like that? what i am asking is does the rod hit directly on both ends? i thought there was a little puck on the clutch assembly side but the parts...

Ok, I greased up my steeringbearings... and when I should put things together again I couldn´t rember in what order.... This is how I mounted it...from bearing and up... first the adjustmentscrew... straight against the bearing... then the dustprotector... then the upper tripleclamp...

All, I am in discussion with dan from motoxotica, there seems to be a bit of confusion on my part, (go figure) regarding the seal or seals that are used. On my 98 fe600e there were two seals that prevented the mixing of oil and water, When i disassembled the water pump and removed the...

Does anyone make a longer pull throttle cable,assembly for FCR or Dellorto carbs?Easier in tight terrain with larger displacement engines to control power,thanks.