Weep Hole Oil Leaking with new seal and bearing
Help Support Husaberg:
Many thanks.
My bike (2001 FE400E) had the bearing seal installed on the water pump side of the bearing. Is that correct?
I don't see any doc pictures that show it clearly. Seems to me like the seal should be on the inside, toward the gear.
thanks,
Greg
I don't see any doc pictures that show it clearly. Seems to me like the seal should be on the inside, toward the gear.
thanks,
Greg
Similar question. Weep hole on the water pump still leaking some oil; I bought a new KTM blue seal. My question is this - where should that seal be positioned? By that I mean how far in/out along the shaft should it be positioned?
I've place it flush to surface of the pump cavity. Should I have shoved it in deeper, so next to the bearing?
thx,
cm
- Joined
- Oct 30, 2003
- Messages
- 955
- Location
- Sweden
Step 1: Mount the sealing onto the bearing to avoid the risk of the lip not slipping over the inner ring of the bearing.
Step 2: Push the bearing down into the transmission cover, with the sealing side first, until it bottoms out. Use your hands and gentle "massage" with a plastic/rubber hammer/mallet.
Step 2: Push the bearing down into the transmission cover, with the sealing side first, until it bottoms out. Use your hands and gentle "massage" with a plastic/rubber hammer/mallet.
- Joined
- Apr 13, 2007
- Messages
- 377
- Location
- Orange, New South Wales, Australia
if i keeps leaking i made the kit to fix it ORANGEBERG weephole kit, contact me JOHN
Similar threads
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
