Help Support Husaberg:
ned37
Moderator
- Joined
- Dec 13, 2004
- Messages
- 2,462
- Location
- back in cottonwood, az
i doubt if you'd be able to get a torque wrench on them. a good tightening tecnic is to choke up on the 4mm allen wrench and just snug them enough to no not vibrate loose and not too much to warp the cover (or strip the thread). i believe they are 5mm fine thread and prolly would be less than 10 footpounds max. too many people overtighten them. dry the cap surface and apply a slight film of sealant, let it tack up for a bit and put on a dry gasket to fix it to the cap. leave the cam cover dry and the next time you go in, the gasket will easily come off with the cap.
Similar threads
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
