Should I mod my Delorto Carby on o2 fe400e?
Help Support Husaberg:
- Joined
- Jan 12, 2002
- Messages
- 159
- Location
- Iceland
Why mod something whis is working well ?
And what do you want to improve with the carburation ?
Heimir Bardason
And what do you want to improve with the carburation ?
Heimir Bardason
- Joined
- Dec 2, 2002
- Messages
- 200
- Location
- Michigan
Hello,
My carbeurator was modified by Lineaweaver, The difference is simple
It starts 2nd kick almost everytime and does not fart and stall as easy when throttle is chopped if you are not experiencing problems with starting and or stalling
I personally would just leave well enough alone!
My carbeurator was modified by Lineaweaver, The difference is simple
It starts 2nd kick almost everytime and does not fart and stall as easy when throttle is chopped if you are not experiencing problems with starting and or stalling
I personally would just leave well enough alone!
- Joined
- Nov 20, 2001
- Messages
- 17,032
- Location
- Ely, England
after 30 tests i was running the 470 jetting with the /30 slidecutaway. superb! power wheelies in second WITHOUT leaning back AND on 14/48 gearing.
try the 470 jetting which you'll find in your manual. to get to a /30 slide just take 1mm off the bottom. i however only took .75 mm off in the end.
is there any point in telling you this though if you aren't going to actually ACT upon it :roll: :roll:
know what i'm saying :wink:
Taffy
try the 470 jetting which you'll find in your manual. to get to a /30 slide just take 1mm off the bottom. i however only took .75 mm off in the end.
is there any point in telling you this though if you aren't going to actually ACT upon it :roll: :roll:
know what i'm saying :wink:
Taffy
- Joined
- Nov 20, 2001
- Messages
- 17,032
- Location
- Ely, England
about 100mph in second-smell anything?
8) :twisted: :evil: :twisted: :evil:
you take .75mm off the bottom of the slide thus reducing the cutaway height from /40 (4mm) to /30 (3mm) and as i've said i only machined .75mm off saving the purchase price of a new slide. the rest i trust you can follow from reading the manual.
it makes the same air go through a smaller hole creating an even faster stream of air which announces 'more suck' to the atomizer' demanding more fuel which means get a smaller PJ which means that everything is smaller and sharper.
Taffy
8) :twisted: :evil: :twisted: :evil:
you take .75mm off the bottom of the slide thus reducing the cutaway height from /40 (4mm) to /30 (3mm) and as i've said i only machined .75mm off saving the purchase price of a new slide. the rest i trust you can follow from reading the manual.
it makes the same air go through a smaller hole creating an even faster stream of air which announces 'more suck' to the atomizer' demanding more fuel which means get a smaller PJ which means that everything is smaller and sharper.
Taffy
- Joined
- Feb 11, 2003
- Messages
- 141
- Location
- Corona California
flat or round
Taffy is that a round slide or flat.
Taffy is that a round slide or flat.
- Joined
- Feb 11, 2003
- Messages
- 141
- Location
- Corona California
round
And what part of the throttle opening from idle to full did that help.Thanks.
And what part of the throttle opening from idle to full did that help.Thanks.
Similar threads
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
