Sem stator ST5500L

supermoto690 · Aug 24, 2018

Hey guys I have ST5500L stator on my bike from electrex and I think its dead, I wanted to go for a ride yesterday but I have no spark, I tested the 3 wires, black and red show 1 on multimeter, green and black show 0,shouldnt there be atleast some small resistance or is it completely dead, I used to ride the bike everyday no problem it didint give me any warnings it was very easy to kickstart everytime, hope someone can guide me here, thanks.

Taffy · Aug 25, 2018

yes, you should have had 3,000 ohms or even 3,150 on the red to black and about 170ohms on the green to black.

Taffy

supermoto690 · Aug 25, 2018

Ok I just checked again and my numbers are going everywhere it reads from 900ohms to 1900ohms but the thing I dont understand is it doesnt give me any reading unless I tap on the those multimeter bolts plus and minus I dont know how is it called, so I have to put it in and out of the wire to get the reading if i keep on the two wires it just shows 1.sorry for bad explanation my eng is not soo good.

Taffy · Aug 25, 2018

they give a 'flash' reading. I understand this. it is still a faulty stator. check some other electrical goods to make sure it isn't the multimeter.

cheers

Taffy

supermoto690 · Aug 25, 2018

Yes that is it a flash reading thank you, yes I checked other stuff they show good steady reading, even the black and green show steady 165ohms,its just the black and red that I need to tap on to get the reading and it is never the same reading. Thank you very much I ordered a new stator from Horse power ignition.

supermoto690 · Aug 30, 2018

Just a quick update I got my stator installed it, works like a charm 1st kick start after 1 week of not running, I just have a question, my magnets on flywheel are chiping off, is it possible to glue them somehow?

Sem stator ST5500L

Help Support Husaberg:

supermoto690

Taffy

supermoto690

Taffy

supermoto690

supermoto690

Similar threads

Register CTA

Recent Discussions

Recent Discussions