Help Support Husaberg:
- Joined
- Apr 21, 2002
- Messages
- 1,142
- Location
- fallon nv
Take the bolts that go through the rocker out of the right side and then you may need to use a thin drift pin in the bolt hole to start the rocker out. Put a longer bolt in the end and you can use a pair of pliers to pull the rocker out. Once you get it to move you can usually go back and forth with it until it comes all the way out.. Corse you can always make a puller out of a deep socket and a flat washer and bolt.
Good luck
Good luck
Well, one of the two end caps was a pain to remove. I manage to hammer it out, I knicked the outside of it a little bit, it should not be a problem but I hate having to do that.
I thought about the longer bolt and I did just that but one was easier to get out.
I thought about the longer bolt and I did just that but one was easier to get out.
Similar threads
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
