Race Head

LINEAWEAVER · Jun 1, 2006

New photo added.

Flow Testing a Husaberg Race Head

37 mm / 32.5 mm Titanium Valves as per Husaberg R&D.

:wink:

Dale

whosahberg · Jun 1, 2006

mr lineaweaver sir

could you give us a rundown on the workings of the flow test device ?

LINEAWEAVER · Jun 2, 2006

whosahberg said:
mr lineaweaver sir

could you give us a rundown on the workings of the flow test device ?

With a smile I shall.

Flow Bench 101

Dale

berger · Jun 2, 2006

I'm having problems with your link Dale

LINEAWEAVER · Jun 2, 2006

berger said:
I'm having problems with your link Dale

Give er another go.

SFO · Jun 9, 2006

Dale, if you are doing a/b testing with head mods is it sufficient to model just a bare port?
I.e., no inlet manifold or carb and no ex header?
I learned treating the engine as system from you, and I sort of expected to see more stuff hanging on the head.
Would be interesting to do an a/b with the stock right angle inlet and a straight shot k&n.

LINEAWEAVER · Jun 9, 2006

SFO said:
Dale, if you are doing a/b testing with head mods is it sufficient to model just a bare port?
I.e., no inlet manifold or carb and no ex header?
I learned treating the engine as system from you, and I sort of expected to see more stuff hanging on the head.
Would be interesting to do an a/b with the stock right angle inlet and a straight shot k&n.

If I showed everything I would no longer be of value. :wink:
The picture was more with regard to the equipment then that of the head.

Sincerely,
Dale

SFO · Jun 11, 2006

What DL is to me is a far bigger picture, IMHO.

Race Head

Help Support Husaberg:

LINEAWEAVER

whosahberg

LINEAWEAVER

berger

Moderator

LINEAWEAVER

SFO

LINEAWEAVER

SFO

Similar threads

Register CTA

Recent Discussions

Recent Discussions