- Joined
- Mar 21, 2005
- Messages
- 16
- Location
- Unknown
I'm trying to install an '04 complete Husaberg FS 650 Exhaust on an FC 501 '97 model.
I have my welder ready to weld some brackets but my problem and question is:
The kickstarter will hit the mid pipe severely hanging it out.
Is the '04 kickstarter bent to go around the pipe and if so do you know if the shaft & splines are the same?
If so, this would save me a lot of pipe bending.
TIA
I have my welder ready to weld some brackets but my problem and question is:
The kickstarter will hit the mid pipe severely hanging it out.
Is the '04 kickstarter bent to go around the pipe and if so do you know if the shaft & splines are the same?
If so, this would save me a lot of pipe bending.
TIA
