- Joined
- Sep 19, 2003
- Messages
- 121
- Location
- USA,Eugene, Oregon
Is there a special tool you must use or can a tool be made to tighten/loosen hex nut holding inner clutch hub on 2006 model.
inner clutch hub nut
- Thread starter wooleyberger
- Start date
Help Support Husaberg:
- Joined
- Oct 22, 2005
- Messages
- 935
- Location
- Texas
wooleyberger said:
Easiest way is to use an air powered impact--no special tool needed, it spins right off.
An easy way to make a tool to keep the clutch assembly from spinning is to take one old steel plate and one old fiber plate, position them in the hub/basket so everything lines up, and drill a couple of small holes and bolt them together.
Now you have a cheap and free clutch holding tool.
- Joined
- Feb 4, 2007
- Messages
- 23
- Location
- Greenville, SC, USA
Johnf3 said:
That's an excellent tip. One question though, how do you keep the entire clutch from spinning? The book shows a gear segment tool is needed to lock the assembly to the primary drive gear.
Lou.
- Joined
- Sep 19, 2003
- Messages
- 121
- Location
- USA,Eugene, Oregon
That is an excellent tip.That is what I like about this site. thanks.
Similar threads
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
