- Joined
- Jun 6, 2008
- Messages
- 1,092
- Location
- Simi Valley Ca.
Hello,
I finally got tired of being too lazy to pull the side cover and check TDC correctly.
So that's what I did. And took a quote from Taffy that he said.
" Staple at 5 oclock then bring to 9 oclock with edge of staple in line with edge of cover screw hole"
Ok, so I wanted to see how close I had been getting with the rigid zip tie method down the plug hole.
And I had been coming up a little short with the staple. I would say by readjusting the valves I needed
to tighten on a few another 1/12th max from my set 1/6th.
So yea I had been setting them a little looser than 1/6th for a while but now they are spot on.
It's about time!
Sometimes it takes a while to learn something so simple I guess.
pollo
I finally got tired of being too lazy to pull the side cover and check TDC correctly.
So that's what I did. And took a quote from Taffy that he said.
" Staple at 5 oclock then bring to 9 oclock with edge of staple in line with edge of cover screw hole"
Ok, so I wanted to see how close I had been getting with the rigid zip tie method down the plug hole.
And I had been coming up a little short with the staple. I would say by readjusting the valves I needed
to tighten on a few another 1/12th max from my set 1/6th.
So yea I had been setting them a little looser than 1/6th for a while but now they are spot on.
It's about time!
Sometimes it takes a while to learn something so simple I guess.
pollo
