- Joined
- Jun 5, 2008
- Messages
- 10
hello all, i have now cross referred my loom to the diagram you helped me get- but now i have no spark does anybody know of any common problems 2001 fe400 road legal thanks for your help
fe400 2001 no spark!!!!!!!
- Thread starter sgreenfe400
- Start date
Help Support Husaberg:
sgreenfe400 said:
Hello sgreen,
The most common problem of this year is the stator, start by taking some resistance readings, should read,
Black to Green 165 Ohms
Black to Red 3000 Ohms
The later reading is the one that generally fails.
Make sure the Black earth lead from the cdi/coil is well connected to ground, and disconnect the orange wire(kill switch).
When looking for a spark remove the HT cap and pull the spark direct from the HT lead.
A good healthy stator will pull a spark gap of around 10 to 12mm on a normal kick.
Let us know how you get on.
Regards
Sparks.
- Joined
- Jun 30, 2005
- Messages
- 449
- Location
- Kings Farth
Good idea actually. The original resistor cap is prone to failure. It happened to me too. Now using a cap without a resistor, since the spark plugs have a built in resistor there will still be some resistance for the spark current and it seems to work well.sparks said:
Regards
- Joined
- Jun 5, 2008
- Messages
- 10
i have checked earth from stator and found it to be o.k. drawing 12 volts any other ideas?
Similar threads
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
