De-restricting the FE 570

Husaberg

Help Support Husaberg:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Dec 25, 2008
Messages
1
Location
Brisbane Australia
Just finished assembling the new 570 (Australia) and wondered if the only power restrictions are:

1. Change Rear Sprocket/chain
2. Remove the screw restricting the turn of throttle
3. Remove the airbox blank and replace with correct one.
4. Remove the snorkel in end of muffler
5. Do you have to get the bergs efi re-programmed if you put an aftermarket muffler?


Thx
Argle
 
Argle said:
5. Do you have to get the bergs efi re-programmed if you put an aftermarket muffler?

yeah there is another efi map you need to get your dealer to download into it's cpu (at least in Australia you do)
 
RE: Re: De-restricting the FE 570

The stock EFI map is setup for the stock restrictions.

When you start removing or modifying these restrictions the stock EFI map has some self-adjusting wiggle room but it's best to dyno the bike, review the dyno graphs, adjust the EFI map, dyno, check the results again and repeat until satisfied.
 

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions

Recent Discussions

Back
Top