Hi brothers i'm sorting out a starter problem and need too remove the clutch basket i'm thinkin i can make a clutch holder from a clutch steel or two and hold it in place with those little steel tubes while i undo the nut any body else tried this i used this method on a few old maico,s but the husaberg clutch baket is different design.......colin
Help Support Husaberg:
- Joined
- Jun 13, 2007
- Messages
- 3,871
- Location
- south east WA Australia
I use a complete clutch pack that I burnt out
installed it then drilled 2 holes through all but the last steel, 2 nails for pins then use 3 of the round dowels in the clutch and a piece of soft alloy to jamb the gears
installed it then drilled 2 holes through all but the last steel, 2 nails for pins then use 3 of the round dowels in the clutch and a piece of soft alloy to jamb the gears
Similar threads
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
