Cam Bearings

Husaberg

Help Support Husaberg:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
B

Badvoc

Joined
Apr 1, 2004
Messages
118
Location
West Sussex, England
Im replacing the cam bearings 6201/c3.
Now do I get rubber sealed bearings or open ones?

Also I have replaced the Cam follower bearings, is one centre punch enough to hold them in or should I do both shoulders? ie each end of the pin?

cfbp.jpg
 
Hi there, i used the open bearings, gotta be better for oil access (?)
On the follower bearings i put three punches on each end of the pin.......... better safe than sorry.
 
bearings can be either IMHO. i've sen some beauties many years old and still perfect with the 2RS. some have just an outer seal. so take your pick!

regards

Taffy
 
Re: RE: Cam Bearings

Taffy said:
bearings can be either IMHO. i've sen some beauties many years old and still perfect with the 2RS. some have just an outer seal. so take your pick!

regards

Taffy
Click to expand...

Agreed. Oil migrates past the seals on the bearings without issue.
 

Similar threads

C
Water pump bearing, how do you get it in without breaking it?
Replies
3
Views
272
heidenberg
H
G
2003 fe501 cylinder head repair/replacement questions
Replies
8
Views
599
Taffy
Taffy
T
570 engine rebuild help!
Replies
5
Views
531
TurboYoda
T
N
Help on oil pump FE 390
Replies
3
Views
966
Nomadahowfar
N
V
2007 Husaberg FS650e water pump seal.
Replies
9
Views
1K
Alfy
A

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions

Recent Discussions

Back
Top