2011 FE 390 Water pump

Husaberg

Help Support Husaberg:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
M

Mookie

Joined
Jul 27, 2013
Messages
2
Hi guys,

If I let my bike run for 5mins water starts to come from the tell tail hole on the water pump, I have been told it will be the two seals inside the water pump and that this is a very simple and quick job to do. So my question is do I need to remove the clutch cover? do I need to remove the other large cover the clutch cover mounts to?
 
You will have a far better result if you remove the entire clutch cover ( large piece ) the water pump impeller is a 2 piece design and it is very easy to break, and the oil seal is recessed pretty deep iirc.
 
Thanks for the help, I have the cover off and I have removed the circlip from the back of the shaft behind the sprocket. but am unsure how the sprocket comes off the shaft as it does not want to move at all. Once I remove the circlip do I push the shaft through?
 
Remove water pump cover and impeller nut first and pull the whole shaft out.
 

Similar threads

C
Water pump bearing, how do you get it in without breaking it?
Replies
3
Views
271
heidenberg
H
V
2007 Husaberg FS650e water pump seal.
Replies
9
Views
1K
Alfy
A
E
Want To Buy Master Cylinder 9.5mm - Husaberg FE 390 2012
Replies
0
Views
156
eric.johnsson
E
N
Help on oil pump FE 390
Replies
3
Views
961
Nomadahowfar
N
H
FE 390 - Clutch Master Cylinder
Replies
2
Views
528
Hsinc
H

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions

Recent Discussions

Back
Top