2010 FE570 oil and filter change level

Husaberg

Help Support Husaberg:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
A

aquajett

Joined
Jul 9, 2008
Messages
36
Location
south australia riverland
just after some info on how much oil is everyone putting in after a full filter and oil change i know the manual states 1350ml but will this make oil level to high as surely you dont get every last drop out
cheers aquajett
 
Dont these new motors come equiped with a level window or a dipstick?
Dont be a sheep (your mates will want to ride you......) think!
I think I get where Taffy is coming from in the 'is the site healthy?' thread.

I must need some cats p*ss.
 
I didn't keep track of how much I put in, but I kept adding oil until it was above the level the manual said was the minimum (half way up the sight glass). I've run it a bit since and I didn't overfill.
 
BERGBRO said:
Dont these new motors come equiped with a level window or a dipstick?
Dont be a sheep (your mates will want to ride you......) think!
I think I get where Taffy is coming from in the 'is the site healthy?' thread.

I must need some cats p*ss.
Click to expand...
yes they do have a site glass BERGBRO and they have a min and max level so there is a bit off scope in how much oil you can have in them and as far as the site being healthy my 08 650 had husaberg written on it and so does my 2010 570
cheers for youre excellent input BERGBRO
 
Put in a bit less than it says in the manual as you're right about there inevitably being some trapped in the engine and it's easier to add more than to take some out. Then see where it ends up and top up if required. I put about 1.2L in initially and that leaves it just a bit low.

It's easier on the FE than on some other bikes as the level is meant to be checked cold, so run the engine briefly to circulate the oil and get the oilways, filter housing etc filled up, stop the engine and wait a while to let the oil drain back down (bearing in mind it will be quite thick as it's not hot) then check the level and top up if it's low. That's my approach anyway; no doubt others will disagree!
 
Hi aquajett,
I remembered this oil post DaleE0 added some good info to. Worth a read I reckon.
I pretty much do it the way petem does it, little less oil than required, then top it up a second time.

http://www.husaberg.org/forum/viewtopic.php?f=1&t=12376

Was gunna post this answer last night but was on the turps again, and thought better off not posting while under the influence :roll:
 
Cheers for that davo that was the post i was looking for but could not find it and it explains everything i wanted to know allso thanks codemonkey and petem for youre input
thanks aquajett
 

Similar threads

N
Help on oil pump FE 390
Replies
3
Views
961
Nomadahowfar
N
F
FE570 low idle issue, outside of the usual suspects! (I think)
Replies
1
Views
420
rikschipp
R
Benjamin Walsh
For Sale 2004 Husaberg 650 supermoto
Replies
0
Views
6
Benjamin Walsh
Benjamin Walsh
K
Red exhaust pipe after slip-on install.
Replies
3
Views
625
MountainBerg
M
W
2010 Fx450 crank no start after engine work
Replies
3
Views
482
waylon
W

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions

Recent Discussions

Back
Top