Help Support Husaberg:
- Joined
- Nov 20, 2001
- Messages
- 17,028
- Location
- Ely, England
i believe you can but you may find that the inlet manifolds are different, also the valve sizes will be different.
you will need to do a check though. make a see-through plastic plate to sit on the face of the head. drill a 5mm hole. then put the HEEL of a vernier gauge through the hole and measure the distance from the top edge of the valve to the face of the head. if the plastic is 6mm thick and you measure 12mm then you know that the valve is sat 6mm down into the head.
do this for an inlet and an exhaust in both heads. you are making sure how deep the valves are sitting ok?
a clear perspex sheet. like a pane of glass but plastic!
finally, if this is different then your came timing will be different. so let's hope that the two heads are the same?
why not tell us when you are done.
regards
Taffy
you will need to do a check though. make a see-through plastic plate to sit on the face of the head. drill a 5mm hole. then put the HEEL of a vernier gauge through the hole and measure the distance from the top edge of the valve to the face of the head. if the plastic is 6mm thick and you measure 12mm then you know that the valve is sat 6mm down into the head.
do this for an inlet and an exhaust in both heads. you are making sure how deep the valves are sitting ok?
a clear perspex sheet. like a pane of glass but plastic!
finally, if this is different then your came timing will be different. so let's hope that the two heads are the same?
why not tell us when you are done.
regards
Taffy
Similar threads
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
