Valve adjusment Husaberg 450fe 06

Husaberg

Help Support Husaberg:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Hi Guys,

The bike run great. Full trottle the engine sound is clean. Only a few back fire going downhill, don't know if it normal.

My only problem is it stall after a few minute or right after I keep the gas full trottle a few second. Seems fine at low idle.

My question is, could it be my valve adjustment the problem? I had this issue before adjusting the valve.
spark plug is new, the head is 100% rebuild with taff's parts.
I'll replace the spark plug cap and make a second run.

thanks!

Daniel
 
Problem solved, I have a weak gas flow probably cause by the gas valve from my second tank.

Many thanks for your help and patience.
 

Attachments

  • IMG_20180729_191719.jpg
    IMG_20180729_191719.jpg
    86.4 KB
Dan0995 said:
Start after the second try. Nice idle, No back fire. Will try it tomorow if I was on the TDC this time ;)
Click to expand...

Hey did you have any issues with your valves after using this method with the flywheel bump at 9 0 clock ? I'm in middle of doing mine for first-time
 
as a GOLDEN RULE to finish this tappet thread off;

I discovered from my mechanics that they also struggled to get the valve clearances right. sure, they'd get a 1/6th-of-a-turn but the tappets were way too tight and the bikes didn't run right.

YOU MUST BE ABLE TO GRAB THE LOCKNUT WITH THE TIPS OF YOUR FINGER AND MAKE MORSE CODE NOISES. THAT NOISE MUST JUST BE AUDIBLE AT THE REAR LICENSE PLATE HOLDER....JUST....NO FURTHER.....NO LESS.

adjust and loosen till you get this noise - JUST at the rear light/plate holder.

Taffy
 
Chris, The bike run like a charm after adjusting the valve. My initial problem was the gas valve on the auxiliary tank almost closed with the vibration.

Thanks again Taffy!
 
Dan0995 said:
Chris, The bike run like a charm after adjusting the valve. My initial problem was the gas valve on the auxiliary tank almost closed with the vibration.

Thanks again Taffy!
Click to expand...
glad to hear. Is this right position on flywheel? Pic is sideways do I align the bump at 9 o'clock bolt on the compression stroke then that's where I'd asjust the valves ?
 

Attachments

  • image.jpg
    image.jpg
    9.9 KB

Similar threads

M
Troubleshooting 2012 450fe
Replies
1
Views
294
Magnussjaa
M
2
New and looking at a fe450 2009
Replies
1
Views
486
o6550
o6550
A
Husaberg Fc 550 doesn’t work
Replies
1
Views
296
Taffy
Taffy
A
Croatian ‘04 fe 450
Replies
2
Views
282
Aronbaron
A
P
Husaberg FC450 No start
Replies
0
Views
289
Putoze
P

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions

Recent Discussions

Back
Top