Wiring hydraulic brake switch to taillight?

Husaberg

Help Support Husaberg:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
M

Michelangelo

Joined
Dec 14, 2009
Messages
56
Location
Utah
I am wanting to hook up my rear LED taillight to my Berg's newly installed hydraulic brake light switch. Can someone provide me a diagram on how to do this?

Taillight has three wires: 1. Black wire=Ground
2. Red wire=Power
3. Brake POSITIVE
0000-acerbis-x-led-taillight-mcss.jpg


Hydraulic switch has two wires: 1. Black wire
2. Black wire

12-0010-hydraulic-brake-switch-1.jpg
 
Last edited:
One end to 12V other end to brake positive. It doesn't matter which black you use, it's just a "switch".
 
As Oregon say is just a switch

You have one ground, that probably is the same for lights and brake, one + for the light, and another + for the brake light. This one will go through the switch.

And it's done
:cool:
 
Now...who can tell me what these three wires are for coming off my OEM harness towards the battery area?

I have a 2009 FE570 but it came without head or taillight. These look like they could be taillight plugs but where would the brake switch be tied in?
 

Attachments

  • Berg Wires.jpg
    Berg Wires.jpg
    89 KB
Power from a fused circuit to one side of the hydraulic switch, the other side of the hydraulic switch to the Brake wire on the tail light. You will have to test to see what wire makes the led illuminate brighter as this will be the brake. The other will be a running light that has less illumination. And of course the ground to a viable ground circuit.
 
FE350 said:
Power from a fused circuit to one side of the hydraulic switch, the other side of the hydraulic switch to the Brake wire on the tail light. You will have to test to see what wire makes the led illuminate brighter as this will be the brake. The other will be a running light that has less illumination. And of course the ground to a viable ground circuit.
Click to expand...

I started my bike up and tested the yellow and red wires and I have ZERO voltage going to either of them. I have all fuses good. Is there an add-on switch (like the front headlight) that I need to add in order to get power to those wires?
 

Similar threads

G
2001 Fe501 - No Spark
Replies
3
Views
489
Taffy
Taffy
W
390 fe lights not working…. Help please
Replies
5
Views
690
Borro
B
M
Electrical Schematic for Low High Beam Switch - Husaberg FE570
Replies
1
Views
269
markp
M
o6550
06 fe550e - Starter Relay wiring
Replies
1
Views
535
o6550
o6550
D
For Sale Parting out my 2001 FE650e
Replies
6
Views
566
Danger666
D

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions

Recent Discussions

Back
Top