How is your rear brake sensor routed?

Michelangelo · Mar 7, 2017

For those with 70 degree Bergs, I'm trying to figure out how the street legal bikes with rear brake banjo bolt sensor have their wire routed to the taillight?

My bike is a FE570 with FMF full exhaust and that pipe is very tight in that area near the rear master cylinder that I'm not sure how I could safely route the sensor wires without risking melting them.

jon andersson · Mar 7, 2017

The wire follows the liner and the connection is a bit to the left from the center hanging free.

My bikes are in parts but you will probably understand the picture anyway.

Michelangelo · Mar 7, 2017

Ok so then it goes underneath the rear part of the tank/subframe and comes up near the battery and CDI?

jon andersson · Mar 8, 2017

The other cable is coming down from the loom, that is routed on the left side, close to the engine. That is hanging loose all the way from the loom.
Just make sure it's free from the shocks movement. One could say it is a relatively sloppy routing, but still quite protected.

rumpel · Mar 12, 2017

Can anybody make a photo of all cable road?

jon andersson · Mar 13, 2017

That would be a good idea! I can remember how it was from the beginning so if someone have an untouched loom please take plenty of pictures and share.

How is your rear brake sensor routed?

Help Support Husaberg:

Michelangelo

jon andersson

Michelangelo

jon andersson

rumpel

jon andersson

Similar threads

Register CTA

Recent Discussions

Recent Discussions