End cap modification

Husaberg

Help Support Husaberg:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
F

F+

Joined
May 1, 2009
Messages
264
Location
Mackay Idaho
Can you see the slits I put in there ? I think it works. I am going to clean up the slits and open them up just a little bit more. I also repacked my clutch with a little bit of dog hair, that seems to be working too.
 

Attachments

  • exaustslits.jpg
    exaustslits.jpg
    19.9 KB
And I went ahead and cut the hole thing out of my bikes anus.
 

Attachments

  • excutout.jpg
    excutout.jpg
    19.6 KB
  • exaustturd.jpg
    exaustturd.jpg
    26.9 KB
If you are in the market for an aftermarket muffler, you might want to try this first.
I just did 70 miles with lots of big Idaho over-reving steap down hills and no screeching or wining anywhere at all.
Almost perfect, a little tuning and a new tire is all it needs.
 
I bet it sounds good too.

i tried just removing the whole endcap, it was painfully loud

I like your solution

the one i made with 3mm thick stainless tube weighs a ton
 
Dude, it all BWWWAAAAAAAAAAAAAAAAAAAAAAAAAAA
Can you guys tell I live alone way out in the sticks ?
 
Did u lose alot of backpresser by taking that pipe out of the end cap and did u feel a couple mph loss on the top speed?
 
Hi

There is another way :D :D

:cool:
ZAGA
 

Attachments

  • Ext_7.jpg
    Ext_7.jpg
    89.3 KB
  • Ext_9.jpg
    Ext_9.jpg
    89.5 KB

Similar threads

C
How bad is this? 2008 FE 550
Replies
4
Views
371
Connecticut_FE550
C
S
300 top end power
Replies
0
Views
228
Slowdirt
S
M
Hello from Franconia
Replies
5
Views
231
Taffy
Taffy
2
New and looking at a fe450 2009
Replies
1
Views
486
o6550
o6550
B
Spark for 2-3 seconds then nothing.
Replies
10
Views
582
mosierz48
M

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions

Recent Discussions

Back
Top