Tools for your Husaberg Motorcycle

FCR Pilot Screw Adjuster

Getting to it from underneath. You need a block connector (UK), an electrician’s screwdriver and 10 minutes work. What you see below is an expensive piece of kit!

It's a block connector, cut in half with a electricians screwdriver in the end. And in that hole on the right is the pinch screw!
It’s a block connector, cut in half with a electricians screwdriver in the end. And in that hole on the right is the pinch screw!
This is a plug cap that was ground down on the outside and it locates on the screw and can't fall off!
This is a plug cap that was ground down on the outside and it locates on the screw and can’t fall off!

Here are some more handy workshop tools and equipment.

Undo Valve Inspection Cover

IKEA allen key seems to do the job (Arkley123)
IKEA allen key seems to do the job (Arkley123)
KEA allen key seems to do the job (Arkley123)
IKEA allen key seems to do the job (Arkley123)

Crankshaft Locking Bolt

Crankshaft Locking Stop Bolt (JoeUSA)
Crankshaft Locking Stop Bolt (JoeUSA)

Shock Rebounder Adjustor

Non-slip shock rebound adjustor tool (Viking)
Non-slip shock rebound adjustor tool (Viking)

Water Pump Shaft Cover

When fitting the sidecover, it needs to fit over the waterpump shaft without being damaged. That way the seal will remain good. (Husabutt)
When fitting the side cover, it needs to fit over the water pump shaft without being damaged. That way the seal will remain good. (Husabutt)

Brake Bleeding

Barry recommends Speed Bleeders for a DIY brake bleeding service!

Stator Pullers – OEM

There are two types of puller – one for the SEM and one for Kokusan engines.

Work Stand

Pivoting workstand sure is handy (Neil_E)
Pivoting workstand sure is handy (Neil_E.)

Clutch and Crankshaft Locking Tools

Factory tool not in stock? Rivet two plates together. Need a gear holder? Cut up an extra primary gear. (Neil_E.)

Factory tool not in stock? Rivet two plates together. Need a gear holder? Cut up an extra primary gear. (Neil_E.)

Factory tool not in stock? Rivet two plates together. Need a gear holder? Cut up an extra primary gear. (Neil_E.)

Splitting the Engine Case

Engine Case Puller (Neil_E.)
Engine Case Puller (Neil_E.)

More Pullers

Bearing race tool, balancer puller, timing sprocket puller (Neil_E)
Bearing race tool, balancer puller, timing sprocket puller (Neil_E.)

Working on the Crank

Crank Stand (Neil_E.)
Crank Stand (Neil_E.)
Crank Stand (Neil_E.)
Crank Stand (Neil_E.)