Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Tech

Tech Mechanical and Technical for the rest of your motorcycle


Reply
 
LinkBack Thread Tools Display Modes
May 6th, 2010, 06:47 PM   #1
Junior Member
 
Joined: May 2010
From:

Posts: 22
Thanks: 0

I Ride:
'10 FX Handlebar mounting dimension?

Was going to order a Scott's under bar mount for new scoot, but found out after reading that FX has narrower spacing on bolt pattern that is on top triple clamp. Can anyone confirm this? The guys at Scott's dampners still show that the FX's are 90 mm spacing, and I think they are narrower... any clue?
ls1yj is offline  
 
May 7th, 2010, 05:08 AM   #2
Senior Member
 
Joined: Oct 2009
From: Virginia Beach, VA

Posts: 261
Thanks: 0

I Ride:
Re: '10 FX Handlebar mounting dimension?

I have raced KTM's for years until getting my FX. My KTM damper and bark buster mounts would not mount up to the FX. The handle bar clamps are 1/2" closer together than the rest. MY KTM stuff was about 4" bar mount to bar mount. The FX is about 3.5". I'm working with Kelly at Motosportz to get a damper made for the FX. No idea how long it will take. I was very surprised the day I went to mount up my damper and stuff from my KTM when it was no where near fitting.
CrazyTed is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Tech

Tags
dimension, handlebar, mounting



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
License Plate Mounting on FE 570 S BlueDevil Tech 9 June 4th, 2011 04:25 PM
conrod dimension contiman Mechanical 3 March 11th, 2010 01:39 AM
Casing dimension needed.. nlan Mechanical 3 October 1st, 2009 01:28 AM
Water pump impeller dimension required - 04 FE450 rojerk Mechanical 2 October 31st, 2008 09:02 PM
Valve circlip, groove dimension Dr_C Mechanical 6 April 28th, 2008 10:38 PM


Facebook Twitter Google+ RSS Feed