Husaberg
Go Back   Husaberg Forum > Lobby > New Users

New Users Post up here and introduce yourself!


Reply
 
LinkBack Thread Tools Display Modes
April 26th, 2015, 06:48 AM   #1
Junior Member
 
Joined: Sep 2014
From: Sweden

Posts: 4
Thanks: 0

I Ride: Ktm 250 -88 -89 and hopefully Husa 501 -01
Intro

Hi
I'm new to this forum and just want to introduce myself. I got 2 ktm 250 -88-89 and have recently bought a Husa 501 -01 in bits. So as you can see I'm sucker for old bikes with not the best reputation. The -88 runs well after full engine rebuild, the -89 needs a better cylinder, cracked above exhust port. And now to my current problem : i've just started reassembling the 501. After sourcing a conrod for it and had it fitted. It is only 60 mm width not the 62.5 workshop manual says ! I was planning to run it with ballbearings and single balance bearing. What should I do ?
I'm bit lost at the moment
Lollo is offline  
 
April 26th, 2015, 07:59 AM   #2
Senior Member
 
tourist's Avatar
 
Joined: Nov 2012
From: Iceland

Posts: 2,349
Thanks: 779

I Ride: 1 Berg, 1 Zook
That's an interesting project and an interesting conundrum too. Best of luck! - Subscribed!
tourist is offline  
April 26th, 2015, 10:58 PM   #3
Senior Member
 
bushmechanic's Avatar
 
Joined: Jun 2007
From: south east WA Australia

Posts: 3,857
Thanks: 1194

I Ride: 2008 700FK, 2002 628FST
maybe make a spacer if required

you can run the balls with up to about 1mm axial play of the crank

bearings may require some honing to a slip fit on the crank so you can measure axial play
bushmechanic is offline  
Reply

  Husaberg Forum > Lobby > New Users

Tags
intro



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Intro bananagas New Users 2 October 28th, 2014 02:07 PM
Intro and Thanks Shoveler Husaberg 6 April 17th, 2010 05:46 PM
New Member Intro.... Zaffer Husaberg 1 February 17th, 2010 11:26 AM
Intro timberger Husaberg 3 August 4th, 2008 05:10 AM
Hellow, new member intro wpbarlow Husaberg 4 October 21st, 2005 04:53 AM


Facebook Twitter Google+ RSS Feed