Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Reply
 
LinkBack Thread Tools Display Modes
October 27th, 2008, 03:14 PM   #1
Junior Member
 
rojerk's Avatar
 
Joined: May 2005
From: Melbourne, Australia

Posts: 20
Thanks: 0

I Ride:
Water pump impeller dimension required - 04 FE450

Hi guys,

I was after a dimension of the water pump impeller if anyone was able to help me out. The dimension I am after is the depth of the shaft boss (i.e. length of the surface which bears against the shaft).

My impeller is able to float a couple of mm's on the shaft before being retained by the circlip and is currently measuring 11.4mm.

Thanks!
rojerk is offline  
 
October 27th, 2008, 04:33 PM   #2
Senior Member
 
bushmechanic's Avatar
 
Joined: Jun 2007
From: south east WA Australia

Posts: 3,772
Thanks: 1065

I Ride: 2008 700FK, 2002 628FST
yes 11.4mm

I put a longer pin in mine and a small shim under the circlip to tighten it up.

regards
Bushie
bushmechanic is offline  
October 31st, 2008, 09:02 PM   #3
Junior Member
 
rojerk's Avatar
 
Joined: May 2005
From: Melbourne, Australia

Posts: 20
Thanks: 0

I Ride:
Thanks very much Bushie - much appreciated.
rojerk is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
dimension, fe450, impeller, pump, required, water



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
2009 FE450 water pump cybertoothtiger Cooling Systems 4 October 14th, 2014 06:48 AM
04 FE450 Water pump impeller shredded, Misterberg Cooling Systems 3 July 24th, 2011 11:25 PM
Water pump impeller leak? jlburgess Husaberg 15 May 14th, 2011 03:55 PM
upgraded water pump impeller, and oil pump?? bulgarian Husaberg 2 April 22nd, 2011 08:54 AM
Water Pump Impeller Husadawg Cooling Systems 1 May 10th, 2005 05:30 AM


Facebook Twitter Google+ RSS Feed