Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Reply
 
LinkBack Thread Tools Display Modes
February 17th, 2008, 07:47 PM   #1
Junior Member
 
Joined: Feb 2008
From:

Posts: 1
Thanks: 0

I Ride:
Silicon in oil screen

When changing the oil in my fe650 04 today the oil screen was covered/full of silicon. Had the transmission and waterpump covers off 5h ago and used the old gaskets together with blue silicon (apparently too much).

Question is if any damage has been done to the engine. Looked at the oil circuit picture in the manual and as oil is pumped throgh the screen up to the paper filter, piston etc then I guess it's not so good to have a screen full of silicon. The silicon had a glue-like consistence (had to use a knife to remove it) so I guess oil would have some problems flowing through it. Will change paper filter and flush it a few times and see if anymore silicon ends up in/on the screen.
peterolsson is offline  
 
February 17th, 2008, 09:09 PM   #2
Senior Member
 
Joined: Jan 2002
From: Los Alamitos, CA

Posts: 517
Thanks: 11

I Ride:
RE: Silicon in oil screen

Just clean it out, should be fine...
PowerCell is offline  
February 17th, 2008, 11:34 PM   #3
Senior Member
 
Joined: Nov 2001
From: Ely, England

Posts: 15,430
Thanks: 399

I Ride: Husaberg FE501e 2003
RE: Silicon in oil screen

don't panic. you'll be ok now you've sussed it and what's done is done.

regards

Taffy
Taffy is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
oil, screen, silicon



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
oil screen The foolish fellow Mechanical 4 November 1st, 2012 06:26 AM
Upper oil screen atk_nut Mechanical 4 March 1st, 2012 07:35 AM
Oil Screen Question Cota Mechanical 1 March 3rd, 2006 10:13 AM
Silicon Nitride cam followers JoeUSA Mechanical 2 April 28th, 2004 07:50 PM


Facebook Twitter Google+ RSS Feed