Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Reply
 
LinkBack Thread Tools Display Modes
April 27th, 2007, 06:59 PM   #1
Junior Member
 
Joined: Mar 2007
From:

Posts: 20
Thanks: 0

I Ride:
Clutch cable lock nuts

I have a quick question. I went to adjust the clutch on my 98 FE400e and found that down where the cable ends at the engine case there is a spot where the threaded portion of the cable housing goes through a small hole. The cable then attaches to the clutch lever. On my bike there are two adjusting nuts both on the same side of the hole. Both are on the side towards the front wheel. Logic tells me one or both of these nuts should be to the rear of this hole. Is the arrangement I discribe correct?
longshanks is offline  
 
April 27th, 2007, 07:37 PM   #2
Moderator
 
ned37's Avatar
 
Joined: Dec 2004
From: back in cottonwood, az

Posts: 2,297
Thanks: 183

I Ride: '08 HUSKY te610
hey now, lets not let logic get in the way they both go in the front, tightened against each other. you could put one in front and one in back, but that would make it harder to take the cable off.
ned37 is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
cable, clutch, lock, nuts



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
where to find a clutch cable for a 1999 FE 501 cgehr Husaberg 3 May 17th, 2011 12:04 PM
Seriously, how big are my nuts? (Axle nuts! FE390) Garrison Mechanical 1 January 17th, 2011 09:35 AM
clutch cable for 97' fe501 trigger Husaberg 1 April 7th, 2010 08:43 AM
Need a clutch cable for 99 600 eman369 Husaberg 12 April 8th, 2005 02:03 AM
Clutch cable for a 1998 FE600E Eman Tech 3 September 11th, 2004 07:24 PM


Facebook Twitter Google+ RSS Feed