Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Reply
 
LinkBack Thread Tools Display Modes
September 16th, 2006, 03:51 AM   #1
Senior Member
 
AUSBERG's Avatar
 
Joined: Mar 2005
From: Sunset desert/ Murray River. S.A/Victoria Australia

Posts: 514
Thanks: 3

I Ride:
Counterbalancer bearing dimensions please ?.

Hi all,
The 03 650 is coming down soon to fix its failed crank.

One bearing ( actually 2) bearings I cannot source as aftermarket (read cheaper) are the double counterbalancer bearings- because I have been unable to find any manufacturers(not Husabergs) part numbers for them.

Accorording to info I have is that Husaberg may have taken an off the shelf bearing, and narrowed it as required, and if thats the case it is not an issue as I have access to a precision NAGASE surface grinder at work.

So what I need is the OD, ID and width of these bearings-preferably prior to stripping my engine so I can can have them on hand ready to go.

I have done a search and checked the doc ( Im a good lad, ey Taff ) but no luck with finding this info

Any help would be appreciated guys.

Cheers all , its beer o'clock
AUSBERG is offline  
 
September 16th, 2006, 04:37 AM   #2
kez
Senior Member
 
Joined: Sep 2004
From: Sunny Surrey,England

Posts: 312
Thanks: 0

I Ride:
RE: Counterbalancer bearing dimensions please ?.

Just Balance The Crank,Its In The Doc< Then You Can Take It Out Completely,If Your Getting A New Crank Go For The Later One With The Larger Crank Pin,Think It Fits.
kez is offline  
September 17th, 2006, 06:46 AM   #3
Senior Member
 
Simon's Avatar
 
Joined: Jun 2001
From: Berkshire, England

Posts: 1,453
Thanks: 3

I Ride:
Ausberg,

Buy the Husaberg bearings and be done with it. I did the rounds on this one a few years ago before the double bearings were even available from Husaberg!

I personally do not believe they're getting off the shelf bearings and grinding them (although this is where it started), the overhead on that would be silly.

Simon
Simon is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
bearing, counterbalancer, dimensions



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
counterbalancer alignment adam85 Mechanical 5 August 27th, 2017 05:48 AM
Dimensions of a >2000 sprague bearing? Taffy Mechanical 4 December 23rd, 2011 09:23 AM
counterbalancer - removal - oil jet? bushmechanic Mechanical 27 March 4th, 2009 02:15 AM
Counterbalancer again Aspen Mechanical 8 September 28th, 2005 05:06 AM
counterbalancer install tm-enduro Mechanical 3 January 24th, 2005 03:34 AM


Facebook Twitter Google+ RSS Feed