Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Reply
 
LinkBack Thread Tools Display Modes
December 27th, 2021, 10:44 AM   #1
Member
 
Joined: Nov 2019
From: Warszawa

Posts: 58
Thanks: 8

I Ride: HUSABERG FC 600 98 HUSABERG FC 600 00 Husqvarna Tc 610 94 husaberg fe 501 93 ,Honda Crf 450 04
Husaberg 600 89-00

How is the timing gear to be installed because I do not remember anymore - it can be put on each side, I assumed that by putting on the upper sprocket and pressing it at 80Nm, it presses the one underneath and I gave it a distance from the side of the second sprocket
gamer3210 is offline  
 
January 1st, 2022, 05:13 AM   #2
Member
 
Joined: Jan 2014
From: Germany

Posts: 41
Thanks: 32

I Ride:
The timing chain gear is installed with the flat side facing towards the clutch cover.The primary gear is conical inside.Itīs getting its final position when tightening the nut (as you have described).
jojo09 is offline  
January 3rd, 2022, 12:26 AM   #3
Member
 
Joined: Nov 2019
From: Warszawa

Posts: 58
Thanks: 8

I Ride: HUSABERG FC 600 98 HUSABERG FC 600 00 Husqvarna Tc 610 94 husaberg fe 501 93 ,Honda Crf 450 04
Hi, I think the timing gear must be directed with the distance towards the clutch cover.
why ?
if I were to do the opposite, there would be no play between the sprockets and it would not be possible to install the timing chain
gamer3210 is offline  
January 3rd, 2022, 09:43 AM   #4
Member
 
Joined: Jan 2014
From: Germany

Posts: 41
Thanks: 32

I Ride:
Happy new year. No that's incorrect.
When tightening the nut you will see that there is space.
Also when looking down from the camshaft... You will see the alignment with the timing chain gear.
jojo09 is offline  
January 4th, 2022, 06:08 AM   #5
Member
 
Joined: Nov 2019
From: Warszawa

Posts: 58
Thanks: 8

I Ride: HUSABERG FC 600 98 HUSABERG FC 600 00 Husqvarna Tc 610 94 husaberg fe 501 93 ,Honda Crf 450 04
Can you take a photo ?
gamer3210 is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
600, 8900, husaberg



Thread Tools
Display Modes



Facebook Twitter Google+ RSS Feed