Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Thanks Tree1Thanks
  • 1 Post By Taffy
Reply
 
LinkBack Thread Tools Display Modes
December 11th, 2021, 11:59 PM   #1
Junior Member
 
Joined: Dec 2007
From: brisbane

Posts: 3
Thanks: 0

I Ride:
Timing issue

Good evening,

I was doing some maintenance and when I was assembling the bike I noticed the alignment marks are a little off. The top cam chain indents are parallel to the head but the one on the idler gear is not exactly in between the other two below. I was hoping some one could tell me if the discrepancy is acceptable.

Thanks.
j_wbstr is offline  
 
December 13th, 2021, 12:41 AM   #2
Senior Member
 
Joined: Nov 2001
From: Ely, England

Posts: 16,555
Thanks: 626

I Ride: Husaberg FE501e 2003
yes, they do it a lot. you may not think it looks right but a tooth in either direction would look awful so, where it is is good.

Taffy
Thanks from Nords
Taffy is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
issue, timing



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Timing question/issue Bergi600 Mechanical 3 July 14th, 2016 07:06 AM
1998 fe 600 timing issue scott600 Electrical 22 January 6th, 2012 10:20 AM
clock issue snatch Electrical 0 February 6th, 2011 11:04 AM
adjusting timing with a dial back timing light? mrk3cobra Electrical 6 November 1st, 2008 06:17 AM
spark timing different to cam timing? popup Ride Reports 9 June 7th, 2008 07:15 AM


Facebook Twitter Google+ RSS Feed