Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs

Thanks Tree1Thanks
LinkBack Thread Tools Display Modes
January 27th, 2021, 06:17 AM   #41
Senior Member
Joined: Nov 2001
From: Ely, England

Posts: 16,353
Thanks: 560

I Ride: Husaberg FE501e 2003
yes I can do a piston and a rod. but your friend is talking balls.

I would gladly, take a handful of sand and pour it into my frame while running the bike. I'd do it as a party trick if you you like!

one grain of sand at a time goes in and then goes out. take the throttle plate attached. its a plate. it breaks up and goes down the inlet tract, the inlet valves smash it small enough to go in the cylinder and then it goes out after parhaps a few cycles of the engine.

no damage, no missfire. I've yet to even hear of a plug gap closing which is if noghting else the one thing you can rely on happening!

your mains are gone, the metal spat on the cylinder wall and then the piston rubbed on it. ask him to check the strainer and magnet and there will be ferrous metal all over the two.

sorry mate. BTW, people won't even call me an expert so why should he have that moniker?


Attached Thumbnails
FE650 2002 - Won't run properly-fcr-slide-plate.jpg  
Taffy is offline  

  Husaberg Forum > Mechanical and Technical > Mechanical

2002, fe650, properly, run

Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
For Sale: 2002 fe650 savav2v1 Classifieds 6 May 18th, 2020 03:41 PM
update 2002 fe650 savav2v1 Mechanical 11 April 1st, 2014 12:16 PM
fe650 2002 clutch savav2v1 Mechanical 8 February 20th, 2014 09:18 AM
2002 FE650??? aaronc70 Husaberg 15 March 19th, 2011 09:54 PM
2002 FE650.....? 2Dogs Husaberg 15 June 8th, 2009 01:52 PM

Facebook Twitter Google+ RSS Feed