Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Thanks Tree1Thanks
  • 1 Post By Taffy
Reply
 
LinkBack Thread Tools Display Modes
June 27th, 2019, 02:07 AM   #1
Junior Member
 
Joined: May 2019
From: Finland

Posts: 4
Thanks: 0

I Ride: Husaberg fe 350/600 1992
Husaberg fe 600 -92

Hi i have a problem to change gear to 2-> 3. The lever is so stiff i cant use leg, i have to use hand instead. Where should i look for the problem? Do i need to open whole motor?

Ps. Sry for the bad English.
Thanks for the answers!
Kalle
Kalerv0z is offline  
 
June 28th, 2019, 01:15 AM   #2
Senior Member
 
Joined: Nov 2001
From: Ely, England

Posts: 15,656
Thanks: 447

I Ride: Husaberg FE501e 2003
take the left cover off and look at the selector arm and claw. maybe the bush in the cover is now worn? the later bikes won't allow the backwards/forwards plate to slide nicely across the up/down baseplate. the 'claw' gets a smashed nose like a boxer. remove the blunt material and chamfer the edges.

also, remove the 'star' and turn the selector drum clockwise as much as possible by hand, keep spinning the rear wheel while in gear and keep turning the selctor clockwise to the maximum. then go anti-clockwise just a little-little bit. STOP.

this should be the 'special place' on the star for neutral for the 'wheel' to sit in AND you should have neutral too!

sometimes this 'star' is one place out etc etc.

Taffy
Thanks from Rainerio
Taffy is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
600, gears, husaberg, problem



Thread Tools
Display Modes



Facebook Twitter Google+ RSS Feed