Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Reply
 
LinkBack Thread Tools Display Modes
April 27th, 2004, 05:02 AM   #1
Junior Member
 
Joined: Apr 2004
From: swizerland

Posts: 2
Thanks: 0

I Ride:
fe 501 e 2003

On my fe501, after a 2 hours drive, I've a problem with a nut mounted on the secondary axle, which transmit the movement at weight balancing system and at the distribution chain.
The nut is simply unscrewing by it self after approximately after a 2 hours use.
The nut is unscrewing it self also if is correctly mounted, checked the torque table and locked with "Loctite green label".
Anybody had the same experience ?
Thank very much your for replaying me !
cheers Franco
franco is offline  
 
April 27th, 2004, 07:15 AM   #2
Senior Member
 
Parsko's Avatar
 
Joined: Mar 2003
From: Waterbury, Connecticut, USA

Posts: 581
Thanks: 0

I Ride:
I am unfamiliar with this setup myself, but... I just read about the green stuff from Loctite. I am still not sure how this fairs up against red, but I have used red all over my bike with no problems of fasterners removing themselves.
Make sure you have a clean surface though. Loctite likes an oil free environment.
Parsko is offline  
April 27th, 2004, 07:36 AM   #3
Junior Member
 
Joined: Nov 2003
From:

Posts: 24
Thanks: 0

I Ride:
Isn't the green label stuff intended for bolted assemblys that are already...well, assembled? You might try cleaning both parts real well and using red.
KenR is offline  
April 27th, 2004, 08:28 AM   #4
Senior Member
 
JoeUSA's Avatar
 
Joined: Jun 2001
From: Pasadena Ca.

Posts: 1,355
Thanks: 0

I Ride:
Hi Franko,

I am not sure I understand what nut you are refering to. If its is the nut for the 'Driving Shaft' item 9 of page 30 in the 2003 parts manual, it is susposed to be torqued to 80 Nm, the same as the nut on the crank shaft per page 43 of the 2003 Workshop manual. I find it hard to believe it would 'loosen' by its self if properly torqued.

If that is not the nut you are refering to, please give us the page and item number of it in the 2003 parts manual so we can help you.

regards,

Joe
JoeUSA is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
2003, 501



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
This oil okay for a 2003 FE 650? willodling Tech 4 April 28th, 2013 05:23 AM
FE 450 E 2003??? sixdays Husaberg 9 September 24th, 2009 08:26 PM
2003 FS 650 E help me please!!! racingrash Fuel 4 January 17th, 2007 01:44 AM
FE 650 2003 sparks Electrical 3 October 18th, 2006 12:39 PM
2003 vs Anything Since canaberg Husaberg 3 April 3rd, 2006 11:59 AM


Facebook Twitter Google+ RSS Feed