Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Thanks Tree4Thanks
Reply
 
LinkBack Thread Tools Display Modes
January 4th, 2017, 07:42 AM   #21
Moderator
 
ned37's Avatar
 
Joined: Dec 2004
From: back in cottonwood, az

Posts: 2,167
Thanks: 123

I Ride: 04 FE650E
good luck!
Thanks from tourist
ned37 is offline  
 
January 4th, 2017, 11:52 AM   #22
Senior Member
 
Rainerio's Avatar
 
Joined: Jun 2013
From: San Francisco CA. USA

Posts: 646
Thanks: 140

I Ride: 7 Husabergs two FE570S,FS570 FE390/450,07 FE650,05 FE550,2 Husqvarna's 86 WR400,87 510,09 Buell
You should have it welded and retempered. If your going to use the old crank. Your Way I think will not last very long at All! Hope I'm wrong. But either way start looking for a new crank 1/2. Please let Us know how long it last. Not rubbing it in I been wrong before just good info. to have.......
Rainerio is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
2006, 650, crack, crankshaft



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Crack in intake port FE450-05? erisal Mechanical 4 April 21st, 2010 11:16 AM
FX470 E crankcase crack mito Mechanical 17 January 29th, 2009 08:21 AM
small crack in frame vinman1513 Mechanical 2 September 13th, 2005 07:39 AM
A crack is but a crack,until.... HeimirBardason Mechanical 12 June 21st, 2005 04:39 PM
crack on carb VHSB Jean-yves Fuel 5 April 2nd, 2005 05:17 PM


Facebook Twitter Google+ RSS Feed